Whirlpool 3XLA87W92BQ0 Installatie-instructies - Pagina 2

Blader online of download pdf Installatie-instructies voor {categorie_naam} Whirlpool 3XLA87W92BQ0. Whirlpool 3XLA87W92BQ0 5 pagina's.

Pagina afdrukken
Location
of washer:
Check location
where washer will be installed. Make sure you have everything
necessary
for correct installation.
Proper installation
is your responsibility.
Recessed area instructions...
--
Hot and cold water
-faucets:
Must be
wrthrn 122cm (4 feet)
.
of the back of the
This washer may be installed
in a recessed area or closet.
The installation
dimensions shown
and bottom of door are required.
are the minimum
spaces
Louvered doors with air openings
allowable. Additional
spacing
in top and bottom are
should be considered for ease of
acceptable.
installation and servicing.
Companion
appliance spacing
If closet door is installed, the
should be considered.
minimum
air openings in top
Minimum
installation
spacing
l
Additional
clearances
for wall, door and floor moldings
may be required.
Earthed
electrical
outlet
is required. See
"Electrical requirements,"
Panel A.
L
-water
to washer.
The hot and cold water
inlets on the back of the
washer have 314 -
11-l 12
American hose coupling
standard threads.
closet door
?-
7.6cm
(3")
Support:
Floor must be
sturdy enough to support
155 sq. cm
(24
sq. in.)
T
i
7.6cm
(3")
hmm
/closet
door
L 00
43.2cm
(17")
0 0
t
1
~
35.6
cm
max.
(14"
max.)
+
10.2cm
(4") min.
310 sq. cm
(48 sq. in.)
slope under entire washer -
155 sq. cm
(24
sq. in.)
Ocm
Do Not store or operate
washer
below
0°C (32'F)
(some water may remain in washer).
See Use 6 Care Guide for "Winterizing"
information.
Ocm
Drain system:
Untape and open washer lid. Remove packages, hoses and literature rack from washer.
1. Laundry
tub drain
system:
2. Floor drain
system:
3. Standpipe
drain
system:
Needs a 76-liter (20-gallon)
laundry tub.
Needs
a
two-inch
(51 -mm) minimum
diameter
carry-away capacity of 64 liters (17 gallons) per
minimum
Floor standpipe
drain
Top of
stand
ipe
must cl e at
least 86cm
(34 inches)
high and no
higher than
183cm
1
72 inches)
rom bottom
of washer.
.
86cm
'
\y3;;hes)
min.
i
72 inches) max.
rom end of
drain hose to
bottom
of
washer.
Ifcnger
drain hose is needed, use drain hose extension kit (Part No. 285702). If drain
Both kits are available from Whirlpool-authorized
parts distributors.
hose must be shortened, use kit (Part No. 285442).
Electrical
requirements
Recommended
earthing
method
Electrical
Shock Hazard
Electrical
earth is required
Do
Not use an extension
cord
on this appliance.
with
this appliance.
Do Not earth
to a gas pipe.
Do Not have a fuse in the
Do Not change
the power
neutral
or earthing
circuit.
supply
cord plug.
If it does
Check with
a qualified
not fit the outlet,
have a
electrician
if you are in doubt
proper
outlet
installed
by
as to whether
the appliance
is
a qualified
electrician.
properly
earthed.
Failure
to follow
these instructions
could
result
in
death
or serious
injury.
A
If codes permit : and a separate
_
earthing
wire
is used, it Is
recommended
that
a qualified
electrician
determine
that
the
earthing
path
is adequate.
Panel A
A 230-volt, 50-Hz, 8-ampere, fused
For your personal safety, this appliance
must be earthed. This appliance is
equipped
with a power supply cord
having an earthing plug.
To minimize possible shock hazard, the
cord must be plugged
into a mating
earthing-type
wall receptacle, earthed in
accordance with local codes and
ordinances. If a mating wall receptacle is
not available, it is the personal
responsibility
and obligation
of the
electrical supply is required. Time-delay
fuse or circuit breaker is recommended.
It is recommended
that a separate circuit
serving only this appliance be provided.
1
PkI
k
pCWer
supply cord
Figure
1
customer to have
the
proper earthed wall
receptacle installed by a qualified
electrician.
See Figure 1 to determine
the
proper mating wall receptacle for the
power supply cord plug equipped
with
this washer.