Whirlpool 4GWTW5550 Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 4GWTW5550. Whirlpool 4GWTW5550 27 pagina's.
Ook voor Whirlpool 4GWTW5550: Handleiding voor installatie-instructies (27 pagina's), Handleiding voor installatie-instructies (27 pagina's)

Whirlpool 4GWTW5550 Handleiding voor installatie-instructies
CONNECT DRAIN HOSE
Attach
drain
hose to drain
port
Remove
drain hose form
(floor drain installations
only}
Remove the red plastic plug from the black drain port on the
back of the washer.
If clamp is not already in place on elbow end of drain hose,
slide it over end as shown. Squeeze clamp with pliers and
slide black elbow end of drain hose onto black drain port
and secure with clamp.
For a laundry tub or standpipe drain, go to step 6.
For a floor drain, remove the preinstalled drain hose form as
shown in Step 7. You may need additional parts with separate
directions. See "Tools and Parts".
F6,
Place drain
hose in standpipe
Drain
Place hose into standpipe
(shown in picture) or over side of
laundry tub.
IMPORTANT: 4.5" (114 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay on
bottom of laundry tub. Drain hose form must be used.
For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts".
CONNECT INLET HOSES
Washer must be connected to water faucets with new inlet
hoses with flat washers (provided). Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing
to inlet valves. If you are only connecting to a cold water
faucet, you must use a Y-adapter (provided).
Connect
inlet hoses
to water
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional two-thirds
turn. Repeat this step with second hose
for cold water faucet.
IMPORTANT:
Do not overtighten
or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
6