Whirlpool 4KMEDX505 Handleiding voor installatie-instructies - Pagina 4

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 4KMEDX505. Whirlpool 4KMEDX505 27 pagina's.
Ook voor Whirlpool 4KMEDX505: Handleiding voor installatie-instructies (27 pagina's)

Pagina afdrukken

Wall standpipe

drain system

See requirements for floor standpipe drain system.

Floor

drain

system

(

Floor drain system requires a Siphon Break Kit (Part Number

285834), 2 Connector Kits (Part Number 285835), and an

Extension Drain Hose (Part Number 285863) that may be

purchased separately. To order, please contact the dealer from

whom you purchased your washer or an authorized service

company. Minimum siphon break: 28" (710 mm) from bottom

of washer. (Additional hoses may be needed.)

Laundry tub drain system

Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at

least 39" (990 mm) above floor; install no higher than 48" (1.22 m)

from bottom of washer.

IMPORTANT: To avoid siphoning,

no more than 4.5" (114 mm)

of drain hose should be inside standpipe or below the top of

wash tub. Secure drain hose with cable tie.

ELECTRICAL REQUIREMENTS

Electrical Shock Hazard

Plug into a grounded

3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow

these instructions can result in death,

fire, or electrical

shock.

CAUTION: To avoid a hazard due to inadvertent resetting of the

thermal cut off, this washer must not be supplied through an external

switching device, such as a timer, or connected to a circuit that is

regularly switched on and off by the utility.

[] A 220-240 volt, 60 Hz., AC only, 10-amp, fused electrical supply

is required. A time-delay fuse or circuit breaker is recommended.

It is recommended that a separate circuit breaker serving only this

appliance be provided.

[] This washer is equipped with a power supply cord having

a 3 prong grounding plug. If the supply cord is damaged, it

must be replaced by the manufacturer, a qualified service

agent, or other qualified person to avoid a hazard.

[] To minimize possible shock hazard, the cord must be plugged

into a mating, 3 prong, grounding-type

outlet, grounded in

accordance

with local codes and ordinances.

If a mating outlet

is not available, it is the personal responsibility

and obligation

of the customer to have the properly grounded outlet installed

by a qualified electrician.

[] If codes permit and a separate ground wire is used, it is

recommended

that a qualified electrician determine that

the ground path is adequate.

[] Do not ground to a gas pipe.

[] Check with a qualified electrician if you are not sure the

washer is properly grounded.

[] Do not have a fuse in the neutral or ground circuit.