Whirlpool 8212638RP Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Whirlpool 8212638RP. Whirlpool 8212638RP 29 pagina's.

Pagina afdrukken

ADDING LAUNDRY PRODUCTS

Adding HE detergent to basket:

Single-dose laundry packets, Oxi-

type boosters, color-safe bleach, or

scented crystals can be added to

the drum prior to adding laundry.

When using single-dose laundry

packets, make sure that the Load &

Bulk Dispenser option is

™

disabled (on some models).

NOTE: Follow the manufacturer's instructions to determine the

amount of laundry products to use.

Adding liquid chlorine bleach to single-load dispenser:

Add liquid chlorine bleach to

the bleach compartment. Do

not overfill, dilute, or use more

than 2/3 cup (165 mL). Do not

use color-safe bleach or Oxi in

the same cycle with liquid

chlorine bleach.

IMPORTANT:

� Always measure liquid chlorine bleach. Use a measuring cup

with a pour spout; do not guess.

� Do not fill beyond the "MAX" line. Overfilling could cause

garment damage.

� Do not use thickened, easy-pour, or no-splash bleach when

running the Clean Washer with affresh

may occur.

� On some models: Do not add liquid chlorine bleach to the bulk

dispenser.

� Slowly close dispenser drawers. Make sure the drawers are

closed completely.

Adding liquid fabric softener to single-load dispenser:

Pour a measured amount of liquid

fabric softener into liquid fabric

softener compartment. Always

follow manufacturer's directions for

correct amount of fabric softener,

based on your load size. Disable

the 1 Liter Load & Go

dispenser if

™

not used to dispense detergent.

Fabric softener is always dispensed in the last rinse.

IMPORTANT: Do not overfill, dilute, or use more than the

manufacturer-recommended quantity of fabric softener. Do not fill

past the "MAX" line. Overfilling dispenser will cause fabric softener

to immediately dispense into machine.

� Do not spill or drip any fabric softener onto the clothes.

� Do not use liquid fabric softener dispenser balls in this

machine. They will not dispense correctly.

� Do not use fabric softener sheets, as they can stain the load.

Adding HE detergent to Load & Go

models):

Use only High Efficiency (HE) liquid detergents. The bulk

dispensers will hold about 67.6 oz. (2 L) or 33.8 oz. (1 L) of liquid

HE detergent, depending on dispenser, or enough for many loads

of laundry.

cycle, as excess suds

dispenser (on some

™

To fill bulk dispensers:

Open the dispenser drawer by pulling on the handle at the base of

the machine. If desired, the drawer can be completely removed

from the machine.

Locate the Load & Go

bulk dispenser. Gently

™

pull up on the tab located on the bulk dispenser

lid to lift the fill door.

Fill to the "MAX" line (see illustrations at right)

with HE liquid detergent or liquid fabric softener

(1-liter dispenser only). Close fill door. It will click

into place. Make sure the concentration setting

is correct (see the online "Cycle Guide").

It is recommended that you rinse out the Load &

containers when refilling, when changing

™

detergent types or concentrations, or when the

will not be used for an extended period. For

instructions on cleaning the dispenser cartridge,

see "All-In-One Washer & Dryer Care" in the

"Maintenance and Care" section of your

Owner's Manual.

When you want the machine to use the Load & Go bulk

dispenser for automatic detergent dispensing, make sure that

the Load & Go

bulk dispenser option is enabled (on some

™

models). Also, do not add any detergent to the single-load

dispenser.

Adding HE detergent to single-load dispenser:

Pour a measured amount of HE

detergent into detergent

compartment. For powdered

detergent, lift the selector to the high

position. For liquid detergent, push

down the selector to the low position.

Do not overfill; adding too much detergent may cause detergent

to be dispensed into the machine too early.

When using single-dose dispenser for detergent, make sure that

the Load & Go

bulk dispenser option is disabled (on some

™

models).

Getting the most out of your All-In-One Washer & Dryer:

Your new machine is configured to run wash & dry cycles by

default. You also have the option to run Wash Only cycles or Dry

Only cycles. Refer to the Cycle Guide for additional details.

For optimal drying results and to avoid wrinkling of clothes, do

not load clothes more than half full. Since this unit uses a

ventless drying technology, expect longer dry times compared to

a vented dryer.