Whirlpool 8315965 Handleiding voor installatie-instructies - Pagina 5
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 8315965. Whirlpool 8315965 17 pagina's.
Pagina afdrukken
9.
Stack two corner posts on top of
each other. Tilt washer backwards and
insert corner posts 3 inches (7.6 cm) in
from one side of washer as shown.
Repeat with other corner posts on other
side of washer.
1/2"
(1.3 cm)
base
nut
10.
Use legs and nuts from parts
package. Screw nut down to within
1/2 inch (1.3 cm) of
base.
11.
Insert legs into correct
holes at each front corner
of washer until nuts touch washer.
Do Not tighten nuts until Step 14.
12.
Tilt washer backward and
remove corner posts. Gently lower
washer to floor.
Move washer to its permanent
location. Remove cardboard or
hardboard from under washer.
13.
Tilt washer forward raising
back legs 1 inch (2.5 cm) off of floor.
To adjust rear self-leveling legs, gently
lower washer to floor. Check levelness
of the washer by placing a
carpenter's level on top of the
washer, first side to side; then front to
back.
PAGE 5
14.
If washer is not level, adjust
the front legs up or down. Make final
check with level.
When washer is level, use wrench
to turn nuts on front legs up tightly
against washer base. If nuts are not
tight against washer base, the washer
may vibrate.
15.
Remove the service door of
the meter case. Lift the service door
up at the back and remove. Install
money accepting device (refer to
manufacturers instructions for proper
installation). For machines using coin
slides, use adapter kit (provided with
unit). Replace meter case service
door.
16.
CHECK ELECTRICAL
REQUIREMENTS. BE SURE YOU HAVE
CORRECT ELECTRICAL SUPPLY AND
RECOMMENDED GROUNDING
METHOD.
17.
Check that all parts are now installed.
See parts list, Page 3. If there is an
extra part, go back through steps to
see which step was skipped.
18.
Turn on water faucets and
check for leaks. Tighten couplings if
there is leaking. Do Not overtighten;
this could cause damage to faucets.
19.
Check that you have all of
your tools. Check that the shipping
strap was removed from the back of
the washer and used to secure the
drain hose.
If entire strap is not removed, washer
may vibrate and be noisy.
20.
Plug power supply cord into
grounded outlet.