Whirlpool 8316566 Handleiding voor installatie-instructies - Pagina 7

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 8316566. Whirlpool 8316566 8 pagina's.

Secure the Drain Hose

1. Remove the shipping strap from the power cord. Drape the

power cord over the console.

2. Remove any cardboard used to move washer.

Beaded tie strap

3. Wrap the drain hose to the laundry tub leg or drain standpipe

with the beaded tie strap. Push fastener into the nearest hole

in the beaded tie strap. See view A or B.

If the washer faucets and the drain standpipe are recessed,

put the formed end of the drain hose into the standpipe.

Tightly wrap the tie strap around the water inlet hoses and the

drain hose. See view C.

Properly leveling your washer averts excessive noise and

vibration.

Install the Front Leveling Feet

1. Prop up the front of the washer about 10.2 cm (4") with a

wood block or similar object. The block needs to support the

weight of the washer.

A. Threaded holes for feet

10.2 cm

(4")

2. Screw the locknut onto each foot to within 2.5 cm (1") of the

foot base.

2.5 cm

(1")

3. Screw the feet into the threaded holes at the front corner of

the washer until the nuts touch the washer. Twist the feet to

install.

NOTE: Do not tighten the nuts until the washer is level.

4. Tilt the washer back and remove the wood block. Gently lower

the washer to the floor.

Steps in Final Location

1. Slide the washer to its final location.

2. Tilt the washer forward until the rear of the washer is at least

10.2 cm (4") off the floor. You may hear the self-adjusting rear

feet click into place. Lower the washer to the floor.

A. Self-adjusting feet

3. Check the levelness of the washer by placing a level on the

top edges of the washer, first side to side, then front to back.

10.2 cm

(4")