Whirlpool AWM 5100 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Whirlpool AWM 5100. Whirlpool AWM 5100 19 pagina's.

Pagina afdrukken

BEFORE USING THE WASHING MACHINE

1.Removing the packaging and check

• After unpacking, make sure that the washing

machine is undamaged. If in doubt, do not use

the washing machine. Contact After-Sales

Service or your local retailer.

• Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children,

as they are potentially dangerous.

2.Remove the transit bolts

• The appliance is fitted with transit bolts to

prevent internal damage during transport.

Before using the washing machine you must

remove the transit bolts (see "Installation/

Remove the transit bolts").

3.Install the washing machine

• Remove the protective foil from the control

panel.

• Move the machine without carrying it at the top.

• Install the appliance on a solid and level floor

surface, preferably in a corner of the room.

• Adjust the feet to ensure that the machine is

stable and level (see "Installation / Adjust the

feet").

4.Water supply

• Connect the water supply inlet hose in

accordance with regulations of your local water

company (see "Installation/Connect the water

inlet hose").

• Water supply:

cold water only

• Tap:

3/4" threaded hose connection

• Pressure:

100-1000 kPa (1-10 bar).

For Great Britain & Ireland only:

• Water inlet: hot and cold fill.

The warm water inlet temperature must not

exceed 60°C.

5.Drain hose

• Connect the drain hose to the siphon or hook it

over the edge of a sink by means of the "U" bend

(see "Installation/Connect the water drain hose").

• If the washing machine is connected to a built-

in drainage system, ensure the latter is equipped

with a vent to avoid simultaneous loading and

draining of water (siphoning effect).

6.Electrical connections

• Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturer's instructions and current standard

safety regulations.

• Voltage information, power consumption and

electrical protection data are supplied on the

inside of the appliance door.

• The appliance must be connected to the mains

exclusively by means of a socket with an earth

connection in accordance with established

regulations. The appliance must be earthed by

law. The manufacturer declines all liability for

damage to property or injury to persons or

animals deriving either directly or indirectly

from failure to observe the directions.

• Do not use extension leads or multi sockets.

• Before any maintenance on the washing

machine disconnect it from the mains supply.

• Access to the mains plug or to disconnection

from mains supply via a double-pole switch must

be ensured at all times following the

installation.

• Do not operate the washing machine if it has

been damaged during transport. Inform the

After-Sales Service.

• Mains cable replacement is only to be carried out

by After-Sales Service.

• The washing machine must only be used in the

household for the prescribed uses.

Minimum housing dimensions:

Width:

600 mm

Height:

825 mm

Depth:

600 mm