Whirlpool 3ED25DQ Gebruiks- en onderhoudshandleiding - Pagina 13

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool 3ED25DQ. Whirlpool 3ED25DQ 24 pagina's. No-frost refrigerator-freezers with thirst crusher
Ook voor Whirlpool 3ED25DQ: Gebruiks- en onderhoudshandleiding (30 pagina's), Gebruiks- en onderhoudshandleiding (30 pagina's)

Pagina afdrukken

The water

dispenser

Chilled water comes from a tank behind the meat

drawer. It holds approximately

1.5 L (1% quarts).

When the refrigerator is first hooked up, press

the water dispenser bar with a glass or jar until

you have drawn and discarded 1.9 or 2.8 L (2 or

3 quarts). The water you draw and discard will

rinse the tank and pipes.

Allow several hours to chill a new tankful.

NOTE: The small tray beneath the dispenser is

designed to evaporate small spills. There is no

drain in this tray. Do not pour water into it.

To dispense

water:

1. Press a sturdy glass against the water

dispenser bar.

2. Remove the glass to stop dispensing.

NOTE: Dispense enough water every week to

maintain a fresh supply.

The dispenser

light

To turn on night light, slide dispenser LIGHT

switch to the left. See page 17 for directions for

changing the dispenser light bulb.

Using

the automatic

ice mawer

Here are a few things you will want to know about

your automatic ice maker:

The ON/OFF lever is a wire signal arm.

Down

to make ice automatically.

to shut off the ice maker.

NOTE: Do not turn ice maker on until it is

connected to the water

SUDDIV.

Instructions

for

ice maker water supplv

hook LID are attach-

ed to the back of the refriaerator

cabinet.

It is normal for ice crescents to be attached by a

corner. They will break apart easily.

The ice maker will not operate until the freezer

is cold enough to make ice. This can take

overnight.

If ice is not being made fast enough and more

ice is needed, turn the Refrigerator Control

toward a higher number. Wait a day and, if

necessary, turn the Freezer Control toward C.

Good water quality is important for good ice

quality. It is not recommended

that the ice

maker be connected to a softened water supply.

Water softener chemicals, such as salt from a

malfunctioning

softener, can damage the ice

maker mold and lead to poor ice quality. If a

softened water supply cannot be avoided, it is

important that the water softener be well

maintained and operating properly.

Raise

signal

arm to

stop ice

maker.

Lower

signal

arm to

start ice

maker.