Whirlpool 5VEL88TRAQ00 Gebruiks- en onderhoudshandleiding - Pagina 6
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool 5VEL88TRAQ00. Whirlpool 5VEL88TRAQ00 36 pagina's.
Pagina afdrukken
IMPORTANT:
Depending on the width of the opening, you may need to
n
remove the handle or door to move the refrigerator into the
house.
All graphics referenced in the following instructions are
n
included later in this section after "Final Steps."
Before you begin, turn the control OFF, and remove food and
n
adjustable door or utility bins from door.
Tools Needed: ¹⁄₂" hex-head socket wrench and ³⁄₈" hex-head
socket wrench
Remove and Replace the Handle
Style 1
1. To remove the handle, grasp the lower part of the handle
firmly, and then slide it up and pull the handle straight out
from the door. See Graphic 1-1.
2. To replace the handle, position the handle so that the large
holes in the mounting clips are down and align the holes with
the grommets.
3. Rotate the handle so that the mounting clips are flat against
the door and slide the handle down to engage.
Style 2:
1. To remove the handle, loosen the setscrews located on the
side of handle at each end. See Handle graphic.
2. To replace the handle, tighten the upper and lower setscrews
with the hex key provided. See Handle graphic. Do not
overtighten the setscrews.
Remove Door and Hinges
⁵⁄₁₆
" hex-head hinge screw
1. Unplug refrigerator or disconnect power.
2. Open refrigerator door and remove base grille from the
bottom front of the refrigerator. See Base Grille graphic.
3. Close the refrigerator door and keep it closed until you are
ready to lift it free from the cabinet.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
4. Remove the parts for the top hinge as shown in Top Hinge
graphic.
5. Lift the refrigerator door free from the lower hinge and cabinet
and set aside.
6. Remove the hex head hinge screws and bottom hinge
assembly. See Bottom Hinge graphic.
6
Refrigerator Door
Replace Door and Hinges
1. Replace the parts for the bottom hinge as shown and tighten
screws. See Bottom Hinge graphic. Replace the refrigerator
door.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
2. Assemble the parts of the top hinge as shown in the Top
Hinge graphic. Do not tighten the screws completely.
3. Adjust the door so that the bottom aligns evenly with the
cabinet. Tighten all screws.
Final Steps
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Reset the control. See "Using the Control."
3. Return all removable door parts to door and food to
refrigerator.
WARNING
Electrical Shock Hazard