Clam 8996 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Clam 8996. Clam 8996 2 pagina's. For: voyager/yukon/thermal x runner/tundra/portage

Pagina afdrukken

QTY.

PART NO.

103404

103423

101550

102516

101548

101549

For the Yukon, Yukon TC and Runner Thermal models, CUT THE RUNNERS TO 64" in length.

For Voyager, Voyager TCX, Tundra and Thermal X models, NO CUTTING IS REQUIRED.

1. Position the strips on the base. Using a 3/16" or slightly larger drill bit, drill a hole through runner strip

and base starting at the curved end of the base.

2. Slightly tighten fasteners to hold the strip in place so that you may then bend the runner around the

curved area before drilling the next hole

(If you have trouble bending the Wear Strip to the contour of the base, use a heat gun or hair dryer to

make the Strips more pliable before drilling.)

( Also, apply a small amount of grease to threads of screw to prevent seizing of threads.)

Drill next hole through the runner strip and base and slightly tighten fastener to hold the runner in

place.

4. Keep repeating this procedure EVENLY SPACING for remaining holes and securely tighten all

fasteners when they are all installed.

5 . Repeat same process for remaining runners.

START HERE

PARTS LIST

DESCRIPTION

RUNNER, .3/8 X 2-1/2 X 74 LG

INSTRUCTION, RUNNER KIT

KIT, HARDWARE RUNNER

SCREW,10-24 X 1" PTHMSSS

NUT, 10-24 NYLOCK SS

WASHER, #10 FENDER SS

Runner Kit Installation

64"

74"

(includes the following)

YUKON / YUKON TC- / RUNNER THERMAL

VOYAGER / VOYAGER TCX / ADVENTURE

TUNDRA / THERMAL X / PORTAGE

START HERE