Whirlpool 240-VOLT ELECTRIC DRYER Gebruiks- en onderhoudshandleiding - Pagina 15
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool 240-VOLT ELECTRIC DRYER. Whirlpool 240-VOLT ELECTRIC DRYER 33 pagina's. 240-volt electric dryer
Ook voor Whirlpool 240-VOLT ELECTRIC DRYER: Gebruiks- en onderhoudshandleiding (20 pagina's), Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (32 pagina's)
Pagina afdrukken
1. Disconnect power.
2. Remove hold-down screw and terminal
block cover.
3. Attach a
3
⁄
-inch, U.L.-listed, strain relief to
4
the hole below terminal block opening.
Strain relief should have a tight fit with
dryer cabinet and be in a horizontal
position. Put the power supply cord
through the strain relief.
4. Remove the center terminal block screw.
Remove the neutral grounding wire
(green/yellow wire) from external
grounding screw.
5. Connect neutral grounding wire and the
neutral wire (white) of power supply cord
under the center screw of terminal block.
6. Connect the other two insulated wires to
outer terminal block screws.
7. Connect the green, grounding wire from
the power supply cord to the external
grounding conductor screw. Tighten all
terminal block screws firmly.
8. Tighten the strain relief screws.
9. Insert tab of terminal block cover into slot
of the dryer rear panel. Secure cover with
hold-down screw.
INSTALLATION INSTRUCTIONS
Terminal block cover
External ground
Center silver-colored
connector
terminal block screw
Green/yellow wire
of harness
Center silver-colored
External
terminal block screw
ground
connector
Green wire
of power supply
cord or bare
copper wire
4-Wire Connection with
Frame-Grounding Conductor
Hold-down screw
Neutral wire
(white)
Neutral ground-
ing wire
(green/yellow)
3
⁄
", U.L.-listed,
4
strain relief
15