Whirlpool 240-VOLT ELECTRIC DRYER Gebruiks- en onderhoudshandleiding - Pagina 30
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool 240-VOLT ELECTRIC DRYER. Whirlpool 240-VOLT ELECTRIC DRYER 33 pagina's. 240-volt electric dryer
Ook voor Whirlpool 240-VOLT ELECTRIC DRYER: Gebruiks- en onderhoudshandleiding (20 pagina's), Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (32 pagina's)
Pagina afdrukken
Troubleshooting
Common drying problems
PROBLEM
CAUSE
Not drying
• Lint screen is clogged with lint.
satisfactorily
• Restricted air movement.
• Exhaust vent is crushed or
• Cycle and Temperature Control
• Fabric softener sheets blocking
• Dryer located in room with
• Large amount of moisture in
• Cold rinse water used.
• Load too large and bulky to dry
Dryer will
• Power cord not firmly plugged
not run
• Fuse blown or circuit breaker
• Using a regular fuse.
• Dryer door not firmly closed.
• Start button not firmly pressed.
• Cycle and Temperature Control
30
Exhaust vent or outside exhaust
hood is clogged with lint.
kinked.
knob is set on Air cycle.
exhaust grill.
temperature below 45ºF.
the load.
quickly.
into a live circuit with proper
voltage.
tripped.
knob set to Off.
SOLUTION
• Clean lint screen.
• Run dryer for 5-10 minutes. Hold
hand under outside exhaust hood to
check air movement. If you do not
feel air moving, clean exhaust system
of lint or replace exhaust vent with
heavy metal or flexible metal vent
(see "Installation Instructions").
• Replace with heavy metal or flexible
metal vent (see your "Installation
Instructions").
• Select the right cycle and for the
types of garments being dried (see
"Using Your Dryer").
• Use only one softener sheet per
load and only use it once.
• Move dryer to a location with
temperatures above 45ºF.
• Expect longer dry times with items
that hold more moisture (cottons).
• Expect longer dry times.
• Separate load to tumble freely.
• Plug power cord into a live circuit.
• Replace fuse or reset breaker.
• Replace with a time-delay fuse.
• Close dryer door tightly.
• Press Start button again.
• Set knob to a cycle or time.