Whirlpool 3RAWZ480E Handleiding voor installatie-instructies - Pagina 9

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 3RAWZ480E. Whirlpool 3RAWZ480E 21 pagina's. Electric and gas dryer
Ook voor Whirlpool 3RAWZ480E: Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (28 pagina's)

Whirlpool 3RAWZ480E Handleiding voor installatie-instructies
plug strip
4. Use a small flat-head screwdriver to
remove plug strip from the door opening.
Slide the head of the screwdriver under
the top, middle, and lower part of the
plug strip, being careful not to scratch
the dryer surface. Lift up. Remove the
plug strip from the door opening and
insert in the opposite side.
5. Insert a screw in the 2nd opening from
the top of the hinge opening and
partially tighten. Hang the door by
placing the top hinge keyhole over the
2nd screwhead and tighten the screw.
By putting this screw in first, the door
will hang in place while you insert and
tighten the remaining 4 screws.
6. Close the door and check that it latches
securely.

Complete installation

1. Check to be sure all parts are now
installed. If there is an extra part, go
back through the steps to see which
step was skipped.
2. Check to be sure you have all of your
tools.
3. Dispose of all packaging materials.
4. Check the dryer's final location. Be sure
the vent is not crushed or kinked.
5. Check to be sure the dryer is level. (See
"Level Dryer.")
6. Turn power on.
7. Remove the blue protective film on the
console and any tape remaining on the
dryer.
8. Read "Dryer Use."
9. Wipe the dryer drum interior thoroughly
with a damp cloth to remove any dust.
10. Set the dryer on a full heat cycle (not
an air cycle) for 20 minutes and start
the dryer.
If the dryer will not start, check the
following:
• Electrical supply is connected.
• House fuse is intact and tight; or
circuit breaker has not tripped.
• Dryer door is closed.
11. When the dryer has been running for 5
minutes, open the dryer door and feel
for heat. If you do not feel heat, contact
a qualified technician.
9