Whirlpool 4LEC7646EN0 Handleiding voor installatie-instructies - Pagina 2
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 4LEC7646EN0. Whirlpool 4LEC7646EN0 7 pagina's. Electric and gas dryers
Ook voor Whirlpool 4LEC7646EN0: Gebruiks- en onderhoudshandleiding (27 pagina's)
Pagina afdrukken
Check that you have everything necessary for
correct installation. Proper installation is your
responsibility.
Tools needed for installation:
socket wrench
1
screwdriver
nut driver (shown)
or socket wrench
gun and compound
illips
ewdriver
Tools needed to change door swing:
l
Phillips screwdriver
l
soft cloth or towel
1 Parts supplied for installation:
I
Remove
parts package
from
dryer
drum.
Check that
all parts were
included.
4 leveling
legs
Part No. 3397625
0 1996 Whirlpool
Corporation
1 Parts needed for installation:
Check
local codes and see electrical
and venting
requirements,
Panels A and B, before
purchasing
parts.
Determine
if you will need to purchase
a power
supply
cord kit or power
supply
cable.
Electrical
If using a power supply cord:
Ductwork
Dryer
power
supply
cord must be:
l
U.L.-listed
Four-inch
(10.2
cm) metal
exhaust
vent must be
used.
l
220~volt
minimum
l
30-ampere
l
Type SRD or SRDT
l
At least 4 feet (122 cm) long
The wires that connect
to the dryer
must end in
ring terminals
or spade terminals
with
upturned
ends.
0 @
4-wire rece tacle
(l4-30l5
IL 0 \8
3-wire rece
If
tacle
(10-30
)
4-wire power
supply cord with
ring or spade terminals
and
U.L.-listed
strain relief
L
If connecting by direct wire:
Power supply
cable must match
power
supply
(4-wire
or 3-wire)
and be:
l
flexible
armored
or non-metallic
sheathed
copper
cable (with
grounding
wire).
l
lo-GAUGE
SOLID COPPER WIRE. (Do not use
aluminum.)
Venting
No flexible
plastic
No flexible
foil
Exhaust hood
Do Not use exhaust hoods with magnetic
latches.
Prepared
by Whirlpool
Corporation,
Benton
Harbor,
Michigan
49022
Non-exhausted recessed installations:
require
Exhaust
Deflector
Kit, Part Number
3391278*
Floors sloped greater than 1 inch (2.5 cm):
require
Extended
Dryer
Feet Kit, Part No. 27981 O*
*Available for purchase from your dealer.
Printed
in U.S.A.