Whirlpool 7MWGD2140 Handleiding voor installatie-instructies - Pagina 38
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 7MWGD2140. Whirlpool 7MWGD2140 44 pagina's. Electric/gas dryer
Ook voor Whirlpool 7MWGD2140: Gebruiks- en onderhoudshandleiding (32 pagina's)
![Whirlpool 7MWGD2140 Handleiding voor installatie-instructies](/uploads/products/server2/6834569/6834569.png)
Venting
Venting Requirements
WARNING:
To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
IMPORTANT:
Observe all governing codes and ordinances.
Dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling, attic, crawlspace, or a concealed space
of a building. Only rigid or flexible metal vent shall be used for
exhausting.
4" (102 mm) heavy metal exhaust vent
■ Only a 4" (102 mm) heavy metal exhaust vent and clamps
may be used.
■ Do not use plastic or metal foil vent.
Rigid metal vent:
■ Recommended for best drying performance and to avoid
crushing and kinking.
Flexible metal vent:
(Acceptable only if accessible to clean)
■ Must be fully extended and supported in final dryer location.
■ Remove excess to avoid sagging and kinking that may result
in reduced airflow and poor performance.
■ Do not install in enclosed walls, ceilings, or floors.
■ The total length should not exceed 7¾ ft. (2.4 m).
NOTE: If using an existing vent system, clean lint from entire
length of the system and make sure exhaust hood is not plugged
with lint. Replace plastic or metal foil vents with rigid metal
or flexible metal vents. Review "Vent System Chart" and, if
necessary, modify existing vent system to achieve best drying
performance.
38
Exhaust hoods:
■ Must be at least 12" (305 mm) from ground or any object
Elbows:
■ 45° elbows provide better airflow than 90° elbows.
4"
(102 mm)
Clamps:
■ Use clamps to seal all joints.
■ Exhaust vent must not be connected or secured with screws
See "Venting Kits" for more information.
that may obstruct exhaust (such as flowers, rocks, bushes,
or snow).
Recommended Styles:
Louvered hood
Acceptable Style:
Angled hood
Good
or other fastening devices that extend into interior of duct
and catch lint. Do not use duct tape.
Box hood
Better