Whirlpool AWZ 650 Snelle referentiehandleiding - Pagina 2
Blader online of download pdf Snelle referentiehandleiding voor {categorie_naam} Whirlpool AWZ 650. Whirlpool AWZ 650 2 pagina's.
Pagina afdrukkenPREPARING THE LAUNDRY
1. Check that all fastenings are closed and that
pockets are empty.
2. Turn the articles inside out.
3. Place laundry loosely in the drum to make
sure it doesn't become tangled.
Sort laundry as follows:
A) By care symbols
(on the collar or inside seam):
Suitable for tumble drying
Tumble drying with reduced drying
intensity only
Do not tumble dry
B) By amount and thickness/weight
Whenever the load to be dried exceeds dryer
capacity, separate laundry according to
weight (e.g. towels from thin underwear).
C) By type of fabrics
Cotton/linen: Towels, cotton jersey, bed
and table linen made of cotton or linen.
Synthetics/Easy Care: Blouses, shirts,
overalls, etc. made of polyester or polyamide,
as well as cotton/synthetic mixes.
D) By drying level
• Sort into: iron dry, cupboard dry, etc.
Do not tumble dry: Woollens, silk, nylon
stockings, delicate embroidery, fabrics with
metallic decorations, bulky items such as
sleeping bags, etc.
Important: only use specific indicated dryer-
safe additives and rinse items that have been
treated with stain remover thoroughly in plenty
of water before drying. Only use specific
indicated dryer-safe plastic items and never
dry rubber or articles contaminated with
vegetable oil in the dryer
CHILD SAFETY LOCK
How to use the child safety lock:
1. Open the door.
2. Using a coin or a screwdriver, turn the plastic
screw clockwise by 90°.
Slot vertical: the door cannot be locked.
Slot horizontal: the door can be locked.
SELECTING A DRYING TIME OR A PROGRAMME
AND OPTIONS
Drying Time or Programme and Options:
•
To select a drying time or Programme, turn
the time selector knob clockwise.
•
To select an option (if available), press the
corresponding button.
•
Press the button again to cancel the option.
STARTING AND COMPLETING A DRYING CYCLE
1. Having selected the desired drying time or a
programme and options, press the Start button.
If the laundry is not removed at the end of
the drying cycle, an automatic anti-crease
cycle
will operate for maximum 12 min.
2. On completion of the drying cycle, set the
time selector knob to position "0".
The dryer indicator lamp "On" switches off.
INTERRUPTING A DRYING CYCLE
To interrupt the dryer during operation
1. Set the time selector knob to "Airing".
2. Wait at least 5 minutes before opening the
door to allow the dryer to cool down.
For your safety the drying time stops
automatically if you open the door.
3. To restart, after door opening, close the door
and press the start button again.
MAINTENANCE AND CLEANING
Clean the lint filter at the end of every drying
cycle:
1. Open the door.
2. Pull the filter upwards.
3. Open the filter.
4. Remove lint using a soft brush or your
fingertips.
5. Close the filter.
6. Push the filter firmly back into place.
WATER CONTAINER TOP OR BOTTOM
Empty the water container at the end of every
drying cycle.
1. Pull the handle to remove the water container.
2. Empty the water container.
3. Replace the water container when empty by
pushing it completely back in place.
INSTALLATION STABILITY
When installing your dryer, always carefully
level the dryer by means of the adjustable
feet and check the correct levelling with a
spirit level.
HEAT EXCHANGER
Clean the heat exchanger at least every 3
months. Wipe away any lint/fluff from the
door seal and interior using a damp cloth.
(Please refer to instructions for use)
BUILT-IN INSTALLATION
To built in the dryer (when absolutely
necessary)
1. It is recommended to not remove the worktop.
2. A minimum space of at least 5 cm between
the dryer and the furniture is necessary to
guarantee the correct airflow.
TROUBLESHOOTING GUIDE
If a fault occurs, before contacting our After-
Sales Service, make the following checks to
try and remedy the problem:
Drying takes too long / laundry is not dry enough:
•
Was the correct drying time selected?
•
Was the inserted laundry too wet (Washing
machine spin speed less than 800 rpm? When
the spinning speed is less than 800 rpm the
water container fault may occur during
drying cycle).
•
Is the lint filter dirty (filter indicator lamp on)?
•
Is the heat exchanger dirty? (refer to the
Instructions for use)
•
Is the ambient temperature too high?
The dryer does not operate:
•
Is the power plug properly inserted into the
mains electricity socket?
•
Is there a power failure?
•
Has the fuse blown?
•
Is the door properly closed?
•
Has the drying time been selected?
•
Has the Start button been pressed?
Lint filter or water container indicator lamp on:
•
Is the lint filter clean?
•
Is the water container empty?
•
Is the water container correctly positioned?
•
Is the heat exchanger clean?
Water droplets underneath the dryer:
•
Is the heat exchanger correctly positioned?
•
Has any fluff on the heat exchanger seal
been wiped away?
•
Has any fluff on the door seal been wiped away?
•
Has the water container been positioned
correctly?
AFTER-SALES SERVICE
If, after carrying out the above checks the
malfunction persists or appears again, turn
the dryer off and call our After-Sales Service
(refer to guarantee).
Please specify:
•
The nature of the fault.
•
The dryer type and model.
•
The service code (the number after the word
Service on the adhesive rating plate) on the
right-hand side when the door is open.
•
Your full address and phone number.
5019 307 00334