Whirlpool Cabrio,- WED7300X Gebruiks- en onderhoudshandleiding - Pagina 15

Pagina afdrukken

Whirlpool Cabrio,- WED7300X Gebruiks- en onderhoudshandleiding

First try the solutions suggested here or visit our website at www.whirlpool.com/help

If you experience

Washer not performing as expected (cont.)

Washer not draining/

spinning, loads are

still wet

Incorrect or wrong

wash or rinse

temperatures

Load not rinsed

for assistance and to possibly avoid a service call.

Possible Causes

Empty pockets and use garment bags

for small items.

Using cycles with a lower spin speed.

The washer may be overloaded.

Check plumbing for correct drain

hose installation. Drain hose extends

into standpipe farther than 4.5"

(114 mm).

Not using HE detergent or using too

much HE detergent.

Check for proper water supply.

Energy saving controlled

wash temperatures.

Check for proper water supply.

Not using HE detergent or using too

much HE detergent.

Washer not loaded as recommended.

Fabric softener option not selected.

Small items may have been caught in pump or between basket

and tub, which can slow draining.

Cycles with lower spin speeds remove less water than cycles

with high spin speeds. Use the recommended cycle/speed spin

for your garment.

Overloading or unbalanced loads will not allow the washer to

spin correctly, leaving the load wetter than normal. See "Using

Your Washer" for loading recommendations.

Check drain hose for proper installation. Use drain hose form

and securely attach to drainpipe or tub. Do not tape over drain

opening.

Lower drain hose if the end is higher than 96" (2.4 m) above the

floor. Remove any clogs from drain hose.

Suds from regular detergent or using too much detergent can

slow or stop draining or spinning. Use only HE detergent.

Always measure and follow detergent directions for your

load. To remove extra suds, Select RINSE & SPIN. Do not

add detergent.

Are hot and cold inlet hoses reversed?

Both hoses must be attached to both washer and faucet, and

have both hot and cold water flowing to inlet valve.

Check that inlet valve screens are not clogged.

Remove any kinks in hoses.

Energy Star washers use cooler wash and rinse water

temperatures than your previous washer. This includes

cooler hot and warm washes.

Are hot and cold inlet hoses reversed?

Both hoses must be attached and have water flowing to the

inlet valve.

Both hot and cold water faucets must be on.

Inlet valve screens on washer maybe clogged.

Remove any kinks in the inlet hose.

The suds from regular detergent can cause the washer

to operate incorrectly.

Use only HE detergent. Be sure to measure correctly.

Always measure detergent and follow detergent directions

based on load size and soil level.

The washer is less efficient at rinsing when overloaded.

Load garments in loose heaps evenly around the basket wall.

Do not load above maximum recommended load height. The

washer will not rinse well if overloaded. Load with dry items only.

Use cycle designed for the fabrics being washed.

Add only 1 or 2 garments after washer has started.

When using fabric softener, be sure the Fabric Softener option

is selected.

Solution