Whirlpool CEM2743BQ Handleiding voor installatie-instructies - Pagina 25
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool CEM2743BQ. Whirlpool CEM2743BQ 48 pagina's. Commercial dryer gas or electric
Ook voor Whirlpool CEM2743BQ: Handleiding voor installatie-instructies (48 pagina's)
Pagina afdrukken
CHANGING
TO A 30- OR 60-MINUTE
TIMING
CAM
(on some models)
Electrical
Shock Hazard
Disconnect
power before making cam changes.
Failure to follow these instructions can result in death
or electrical shock.
5. Place new cam (hub side down) over clock shaft. Line up flat
side of shaft with flat side of cam hole. Check that drive lug
is in place.
Drive Lug
Coin-slide
models: You can install the 30-minute
or 60-minute
timing cam (shipped with dryer) as follows:
1. Unplug dryer or disconnect
power.
2. Unlock meter case.
3. Turn the timing cam by hand until the V-shaped notch lines
up below the ratchet tooth.
V-Shaped
Ratchet
Notch
Tooth
6. Turn cam until V-shaped notch lines up with ratchet tooth.
7. Press cam down in place on clock shaft. Make sure that
V-shaped notch clears the ratchet tooth.
4. Insert a narrow, flat-blade screwdriver under the timing cam
near the clock shaft. Gently lift cam straight up and off shaft,
making sure that the V-shaped notch clears the ratchet tooth.
8. Close and lock the meter case.
9. Plug in dryer or reconnect power.
25