Whirlpool CGW9100VQ0 Installatiehandleiding - Pagina 17

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Whirlpool CGW9100VQ0. Whirlpool CGW9100VQ0 40 pagina's. Commercial dryer- gas or electric

Pagina afdrukken

Direct Wire

Method

= U.S. Only

Fire Hazard

Use 10 gauge copper wire.

Use a UL listed strain relief.

Disconnect power before making electrical connections.

Connect neutral wire (white or center wire) to center

terminal

(silver).

Ground wire (green or bare wire) must be connected to

green ground connector.

Connect remaining 2 supply wires to remaining

2 terminals

(gold).

Securely tighten all electrical connections.

Failure to do so can result in death, fire, or

electrical shock.

Direct wire cable must match power supply (4-wire or 3-wire)

and be:

[]

Flexible armored cable or nonmetallic sheathed copper cable

(with ground wire), protected with flexible metallic conduit.

All current-carrying

wires must be insulated.

[]

10-gauge solid copper wire (do not use aluminum).

[]

At least 5 ft. (1.52 m) long.

1. Disconnect power.

2. Remove hold-down screw and terminal block cover.

A. Neutralgroundwire

B. External g round

conductorscrew

C. Center,silver-colored

terminalblockscrew

D. Terminal block cover

andholddownscrew

Install 3A" conduit connector into the hole below the terminal

block opening. Connect flexible metallic conduit and tighten

connector screw. Install direct wire cable through the flexible

metallic conduit.

Direct wire strain relief:

[]

Unscrew the removable conduit

connector and any screws from a

3/4"(1.9 cm) UL listed strain relief (UL

marking on strain relief). Put the threaded

section of the strain relief through the

hole below the terminal block opening.

Reaching inside the terminal block

opening, screw the removable conduit

connector onto the strain relief threads.

[]

Put direct wire cable through the strain

relief. The strain relief should have a tight

fit with the dryer cabinet and be in a

horizontal position. Tighten strain relief

screw against the direct wire cable.

Now complete installation following

instructions for your type of electrical

connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

A. Removable conduit connector

B. Hole below terminal block opening

C. Strain relief threads