Whirlpool Conservator Gebruiks- en onderhoudshandleiding - Pagina 10

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool Conservator. Whirlpool Conservator 12 pagina's. Whirlpool conservator electric and gas dryers

Pagina afdrukken

If lint falls off the screen into the dryer during removal, check

the exhaust hood and remove the lint. See "Checking Your

Vent."

As needed cleaning

Laundry detergent and fabric softener residue can buildup on the

lint screen. This buildup can cause longer drying times for your

clothes, or cause the dryer to stop before your load is completely

dry. The screen is probably clogged if lint falls off the screen.

Clean the lint screen with a nylon brush every six months or more

frequently if it becomes clogged due to a residue buildup.

To wash

1. Wet both sides of lint screen with hot water.

2. Wet a nylon brush with hot water and liquid detergent. Scrub

lint screen with the brush to remove residue buildup.

3. Rinse screen with hot water.

4. Thoroughly dry lint screen with a clean towel. Replace

screen in dryer.

Cleaning the Dryer Interior

Explosion Hazard

Use nonflammable cleaner.

Failure to do so can result in death, explosion,

or fire.

To clean dryer drum

1. Make a paste with powdered laundry detergent and very

warm water.

2. Apply paste to a soft cloth.

Apply a liquid, non-flammable household cleaner to the

stained area and rub with a soft cloth until all excess dye is

removed.

3. Wipe drum thoroughly with a damp cloth.

4. Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments which contain unstable dyes, such as denim

blue jeans or brightly colored cotton items, may discolor the

dryer interior. These stains are not harmful to your dryer and will

not stain future loads of clothes. Dry unstable dye items inside

out to prevent dye transfer.

Removing Accumulated Lint from

Inside the Dryer Cabinet

Lint should be removed every two years, or more often,

depending on dryer usage. Cleaning should be done by a

qualified person.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid

the cost of a service call...

Clothes are not drying satisfactorily

Check the following:

Is the lint screen clogged with lint?

Is the exhaust vent or outside exhaust hood clogged with lint,

restricting air movement? Run the dryer for 5-10 minutes.

Hold your hand under the outside exhaust hood to check air

movement. If you do not feel air movement, clean exhaust

system of lint or replace exhaust vent with heavy metal or

flexible metal vent. See your Installation Instructions.

Is the exhaust vent crushed or kinked? Replace with heavy

metal or flexible metal vent. See your Installation Instructions.

Has a fuse blown, or a circuit breaker tripped? Electric dryers

use 2 household fuses or breakers. The drum may be turning

but you may not have heat.

Has an air dry cycle been selected? Select the right cycle for

the types of garments being dried. See "Drying, Cycle and

Temperature Tips."

For gas dryers, is the valve open on the supply line?

Are fabric softener sheets blocking the grill? Use only one

fabric softener sheet and only use it once.

Is the dryer located in a room with temperature below

45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures above

45ºF (7ºC).

Was a cold rinse water used? Was the load very wet?

Expect longer drying times with items rinsed in cold water

and with items that hold moisture (cottons).

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.

Dryer will not run

Check the following:

Is the power cord plugged in?

Has a fuse blown, or has a circuit breaker tripped?

Was a regular fuse used? Use a time-delay fuse.

Is the dryer door firmly closed?

Was the START button firmly pressed?

Is a cycle selected?

Unusual sounds

Has the dryer had a period of non-use?

If the dryer hasn't been used for a while, there may be a

thumping sound during the first few minutes of operation.

Is it a gas dryer?

The gas valve clicking is a normal operating sound.

Lint on load

Is the lint screen clogged?

Clean lint screen. Check for air movement.