Whirlpool CSP2760TQ2 Handleiding voor installatie-instructies - Pagina 10

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool CSP2760TQ2. Whirlpool CSP2760TQ2 36 pagina's. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

Pagina afdrukken

INSTALLATION INSTRUCTIONS - COINSLIDEASSEMBLY

The collar houses the accumulator timer with actuating arm

and button.

Insert the coin-slide mechanism

through the opening to the left of the

control panel.

The factory-installed

timer is set to provide 45 minutes (4 pins)

of drying time when activated by the coin slide. Timer cams for

30-minute (6 pins) and 60-minute (3 pins) drying times are

included in the parts bag.

The coin-slide mechanism, control panel lock and key, and

coin-box lock and key are not included and are available

from usual industry sources.

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

Using two or more people, move dryer to desired installation

location.

2. Check that each leg is approximately

1" (25 mm) from base.

3. Wipe the interior of the drums thoroughly with a damp cloth.

4. Install coin vaults and locks (not supplied) into meter case

openings.

5. Install control panel lock and key (not supplied).

6. If you wish to change the 45-minute dryer timing cams to

either 30- or 60-minute timing cams, see "Changing to a

30- or 60-Minute Timing Cam," section. Complete all of the

steps given in that section before going to Step 7.

Open control panel and

rest it on the bottom

edge of the opening.

___

Attach slide extension

(with flange pointing

down) to one of the

coin-slide mechanisms.

A. slideextension

9. Secure the coin slide

mechanism from inside the

control panel using the ,_A0"

bolt and washer included

with the slide mechanism.

10. Install the coin box.

11. Repeat Steps 7, 8, 9,

and 10 for the other

coin-slide mechanism.

12. For added security between

the upper dryer and the collar,

insert the cotter hair pin

through the connecting bolt.

13. Close the control panel.