Whirlpool CSP2761TQ4 Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool CSP2761TQ4. Whirlpool CSP2761TQ4 36 pagina's. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

WARNING
- ".isk ofFire"
- Clothes dryer installation
must be performed
by a qualified
installer.
- Install the clothes dryer according
to the manufacturer's
instructions
and local codes.
- Do not install a clothes dryer with flexible
plastic venting materials,
if flexible
metal
(foil type) duct is installed,
it must be of a specific
type identified
by the appliance
manufacturer
as suitable for use with clothes dryers. Flexible venting materials
are
known to collapse,
be easily crushed,
and trap lint. These conditions
will obstruct
clothes dryer airflow and increase
the risk of fire.
- To reduce the risk of severe injury or death, follow
all installation
instructions.
- Save these instructions.
WARNING:
For your safety, the information
in this manual
must be followed
to minimize
I
the risk of fire or explosion,
or to prevent
property
damage,
personal
injury, or death,
j
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this
or any other appliance.
- WHAT TO DO iF YOU SMELL GAS:
® Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Clear the room, building, or area of all occupants.
= Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
• if you cannot reach your gas supplier, call the fire department.
- Installation and service must be performed by a qualified
installer, service agency, or
the gas supplier.
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend
that you use a gas detector approved
by UL or CSA.
For more information,
contact your gas supplier.
If a gas leak is detected,
follow the "What to do if you smell gas" instructions.
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
3