Whirlpool duet GEW9200LQ0 Gebruiks- en onderhoudshandleiding - Pagina 12

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool duet GEW9200LQ0. Whirlpool duet GEW9200LQ0 28 pagina's. Duet electronic electric dryer

Pagina afdrukken

Venting Requirements

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in

death or fire.

WARNING:

To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

4 in. (10.2 cm) heavy metal exhaust vent and clamps must be

used. DURASAFE™ vent products are recommended.

DURASAFE™ vent products can be purchased from your dealer

or by calling Whirlpool Parts and Accessories. For more

information, see the "Assistance or Service" section of this

manual.

The dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, or a concealed space of a building.

Do not use an exhaust hood with a magnetic latch.

Do not install flexible metal vent in enclosed walls, ceilings or

floors.

Use clamps to seal all joints. Exhaust vent must not be

connected or secured with screws or other fastening devices

which extend into the interior of the duct. Do not use duct tape.

IMPORTANT: Observe all governing codes and ordinances.

Improper venting can cause moisture and lint to collect

indoors, which may result in:

Moisture damage to woodwork, furniture, paint, wall-

paper, carpets, etc.

Housecleaning problems and health problems.

Use a heavy metal vent. Do not use plastic or metal foil vent.

Rigid metal vent is recommended to prevent crushing and

kinking.

Flexible metal vent must be fully extended and supported when

the dryer is in its final position. Remove excess flexible metal vent

to avoid sagging and kinking that can result in reduced airflow

and poor performance.

An exhaust hood should cap the vent to prevent rodents and

insects from entering the home.

Exhaust hood must be at least 12 in. (30.5 cm) from the ground or

any object that is in the path of the exhaust (such as flowers,

rocks or bushes, etc.).

If using an existing vent system, clean lint from the entire length

of the system and make sure exhaust hood is not plugged with

lint. Replace any plastic or metal foil vent with rigid metal or

flexible metal vent.

Plan Vent System

Typical exhaust installations

Typical installations vent the dryer from the rear of the dryer.

Other installations are possible.

1. Dryer

5. Clamps

2. Elbow

6. Rigid metal or flexible metal vent

3. Wall

7. Vent length necessary to connect elbows

4. Exhaust hood

8. Exhaust outlet

Optional exhaust installations

This dryer can be converted to exhaust out the right side, left

side, or through the bottom.

Fire Hazard

Cover unused exhaust holes with one of the

following kits:

279818 (white)

279925 (biscuit)

Contact your local dealer.

Failure to follow these instructions can result in

death, fire, electrical shock, or serious injury.