Whirlpool WGD7300DW Handleiding voor installatie-instructies - Pagina 20
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool WGD7300DW. Whirlpool WGD7300DW 44 pagina's. Gas and electric dryer 29" wide models
Ook voor Whirlpool WGD7300DW: Gebruiks- en onderhoudshandleiding (40 pagina's)
Pagina afdrukken
CONNECT INLET HOSES
(Steam Models Only)
For non-steam models, skip to "Connect Vent."
The dryer must be connected to the cold water faucet using
the new inlet hoses. Do not use old hoses.
1.
Turn cold water off, remove and
replace rubber washer
Turn cold water faucet off and remove washer inlet hose.
Remove old rubber washer from inlet hose and replace
with new rubber washer.
2.
Attach short hose and
"Y" connector
Attach 2 ft (0.6 m) inlet hose to cold water faucet. Screw on
coupling by hand until it is seated on faucet. Then attach
"Y" connector to end of the 2 ft (0.6 m) inlet hose. Screw on
coupling by hand until it is seated on "Y" connector.
3.
Tighten couplings
Using pliers, tighten the couplings with additional two-thirds
turn.
NOTE: Do not overtighten. Damage to the coupling can result.
20
4.
Attach long hose to "Y"
connector and tighten couplings
Attach dryer 5 ft (1.5 m) inlet hose ends to the "Y" connector.
Attach washer cold inlet hose to other side of "Y" connector.
Screw on coupling by hand until it is seated on connector.
Using pliers, tighten the couplings an additional two-thirds
turn.
NOTE: Do not overtighten. Damage to the coupling can result.
5.
Attach long hose to dryer fill
valve and tighten coupling
Attach other end of long hose to
fill valve at top of dryer back panel.
Screw on coupling by hand until
it is seated on fill valve connector.
Using pliers, tighten the coupling
an additional two-thirds turn.
NOTE: Do not overtighten. Damage
to the coupling can result.
6.
Turn on cold water faucet
Check that the water faucet is turned on.
30
/
"
1
4
(768 mm)
4"
(101 mm)