CALB SE180 Gebruikershandleiding voor het product - Pagina 9
Blader online of download pdf Gebruikershandleiding voor het product voor {categorie_naam} CALB SE180. CALB SE180 10 pagina's.
Ook voor CALB SE180: Gebruikershandleiding voor het product (7 pagina's)
Pagina afdrukken
Product User Manual
Step 2: Install grouping separators as figure 3.
Lower protector
Installation requirements:
Push the battery grouping separators by one side, and clamp the battery by the snap on both sides without falling down. The grouping
separator should be fitted with the upper and lower separator edge without warping.
Step 3: Install upper protector as figure 4.
Upper protector
Lower separator
Installation requirements:
Push the battery grouping separator by one side, and clamp the battery by the snap on both sides without falling down. The grouping
separator should be fitted with the upper and lower separator edge without warping.
Press the upper protector into the battery and make sure it tight and fit with the battery, with no loose connection between protector
and battery.
13
Grouping separator
Figure 3
Grouping separator
Figure 4
Step 4: Install the pole protector as figure 5.
Pole protector
Upper protector
Lower separator
Installation requirements:
Press the pole protector into the upper protector from up to down, and clamp the protectors by the snaps on both sides without
falling down.
After installation, it should be fixed tight and fully fitted between the battery and protectors with no loosening. The completion of
protectors' installation should be like figure5.
2 .2 CAM series battery pack protection components installation
When the protection components for single batteries are installed fully, you can install the battery packs as you need. Installation of
this section includes fastening clamps, screws, nuts, bus bars, and pole protectors.
Screw
Nut
Fastening clamp
Grouping separator
Figure 5
Pole protector
Bus bar
Figure 6
14