Whirlpool AKR9010/IX Installatiehandleiding - Pagina 9
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Whirlpool AKR9010/IX. Whirlpool AKR9010/IX 15 pagina's.
Pagina afdrukkenDESCRIPTION AND USE OF HOOD
1. Control panel.
2. Grease filters.
3. Lamps.
4. Telescopic flue.
Operation
Use the high suction speed in cases of concentrated kitchen vapours.
It is recommended that the cooker hood suction is switched on for 5
minutes prior to cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating cooking.
•To put on and off the lights:
Press on the disk (T) to put on and off the lights
• To select the available suction speeds:
Turn the disk (T) clockwise to turn on and increase the suction speed
and counter-clockwise to decrease it, and to turn off the hood.
The crown (L) lights to indicate the selected suction speed:
• L1 lit
speed 1 (minimum).
• L1 + L2 lit
speed 2 (medium).
• L1 + L2 + L3 lit
Speed 3 (maximum).
• L1 + L2 + L3 + L4 lit in flashing mode
Speed 4 (intensive), lasting for 5 minutes, then the hood is
placed automatically at speed 2
• L off:
Suction motor off
Filters' Saturation Control
The hood is equipped with a device that indicates when it is
required to perform the filter maintenance
The saturation control device of the grease filter is always active
The control device of the activated carbon filter is usually turned
off To activate it, proceed as follows:
- Turn off the hood.
- Press the disk (T) for more than 5 seconds
The crown (L) lights completely, flashing, and a beep will be heard:
the control device of the charcoal filter is activated. NB = to turn it
off, turn off the hood, press the disk (T), L1 + L2 will be backlit,
flashing; wait for the beep to confirm the deactivation.
The control panel consists of a backlit rotating disk.
Grease filter saturation indicator
L1 + L2 flash when you have to perform maintenance of the
grease filter
Activated charcoal filter saturation indicator
L3 + L4 flash when you have to perform maintenance of the
activated charcoal filter
Reset of filter saturation signal
After filter maintenance, turn on the hood and press the disk (T) for
more than 5 seconds: you will hear a long tone (beep) confirming
the reset.
Note: In case of simultaneous signaling (grease filter and activated
charcoal filter saturation), you must repeat the reset twice.
GB14