FirePro Sigma XT Installatie- en bedieningshandleiding - Pagina 10
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} FirePro Sigma XT. FirePro Sigma XT 14 pagina's. Conventional fire control panel with control unit for aerosol release, system isolation
Ook voor FirePro Sigma XT: Procedure (4 pagina's)
Pagina afdrukken5. Setting up the Devices
Addressing Devices
Before adding a device to the FIP's programming, each device connected to the STATUS SERIAL (RS485) circuit
must be given an individual address. The FIP MUST BE POWERED DOWN BEFORE ANY CHANGES TO DEVICES.
IMPORTANT - Devices with the same address will cause an intermittent fault to be displayed.
Assigning Sign Function
In addition to addressing, signs connected to the STATUS SERIAL (RS485) circuit require their function to be set
using the DIL switches on the bottom of the sign circuit board. The functions of the upper and lower halves of the
sign are split across 3 banks of DIL switches. The recommended sign functions for each type of sign are:
Sigma_XT_signs_m3.5.docx
Sign Circuit Board
LCS Circuit Board
Page 10 of 14