Whirlpool UXT2030ADW0 Installatie-instructies en gebruiks- en onderhoudshandleiding - Pagina 3
Blader online of download pdf Installatie-instructies en gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool UXT2030ADW0. Whirlpool UXT2030ADW0 28 pagina's. 30" (76.2 cm) range hood
Pagina afdrukken
INSTALLATION
REQUIREMENTS
Gather the required tools and parts before starting installation
Read and follow the instructions
provided with any tools listed
here.
Tools needed
For 7" (17.8 cm) round vented installations
7" (17.8 cm)
Vent clamps as
requi!ed
round damper
Part Number
, W10355451,
Caulking
gun and weatherproof
_
caulking compound
_
A
Jgsaw orkeyhoe
saw
Parts supplied
Remove parts from package. Check that all parts are included.
Drywall
_
_
Mounting
_" (1Z:8 Cm)[ound
Ve_t
mounting
plate
_7"
Part
Number W! 0388!68
*
_J
Parts needed
UL ListediCSA
UL Listed/CSA
Approved _/2'!
(13 mm
wire connectors
strain relief
Optional accessories
Power
cord
kit
Part Number
W10355452*
Stainless
Steel cleaner
an d polish
Part Number 31462A*
*For information on ordering, see the "Assistance
or Service"
section.
Location
Requirements
IMPORTANT: Observe all governing codes and ordinances.
•
It is the installer's responsibility
to comply with installation
clearances specified on the model/serial rating plate. The
model/serial
rating plate is located inside the range hood on
the left wall.
•
Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
•
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range
manufacturer
installation instructions
before
making any cutouts.
•
This range hood is recommended
for use with cooktops with
a maximum total rating of 40,000 Btus or less.
•
Grounded electrical outlet is required. See "Electrical
Requirements"
section.
•
All openings in ceiling and wall where range hood will be
installed must be sealed.
These range hoods are factory set for vented installations.
Models that are capable of being installed as non-vented
(recirculating) require charcoal filters. See the "Assistance
or
Service" section for information
on ordering charcoal filters.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured
Home Construction
Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction
and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local
codes.