Whirlpool UXT4036AD Installatie-instructies en gebruiks- en onderhoudshandleiding - Pagina 6

Blader online of download pdf Installatie-instructies en gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool UXT4036AD. Whirlpool UXT4036AD 24 pagina's. 30" and 36" (76.2 and 91.4 cm) range hood
Ook voor Whirlpool UXT4036AD: Installatie-instructies en gebruiks- en onderhoudshandleiding (28 pagina's), Installatie-instructies en gebruiks- en onderhoudshandleiding (24 pagina's), Installatie-instructies en gebruiks- en onderhoudshandleiding (24 pagina's), Installatie-instructies en gebruiks- en onderhoudshandleiding (24 pagina's)

5. Mark Hole Locations

6. Drill Electrical

Opening

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

Using a 11/4"(3 cm) drill bit, drill the hole in the dot marked

previously at the electrical strain relief.

OPTIONAL: Using a 1/8"(3 mm) drill bit, drill pilot holes for the

dots marked previously at each mounting tab at an approximate

45 ° angle in an upward direction.

7. Prepare

Range

Hood

Vents and

Mounting

Tabs

Hold the range hood firmly in place with one hand and bend each

mounting tab (A) upward approximately 90 °.

Mark the hole at the power supply knockout (B).

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

Install Strain Relief

Install a UL Listed/CSA Approved 1/2"(13 mm) strain relief (A).

Mounting

Tabs

Start a #8-18 x %" (4.2 x 16 ram) truss-head screw into the

mounting tab (C) on each side of the range hood as shown in

the inset. Insert the screws approximately

2 turns into the

mounting tab holes.

Non-vent

(Recirculating)

Installations

Remove the (2) T10 ®tTorx ® screws and remove the top, front

rectangular vent cover (B).

1-®TORX and T10 are registered

trademarks

of Acument

Intellectual

Properties, LLC.