Firesense 63246 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Firesense 63246. Firesense 63246 6 pagina's. Round tempered glass wind guard for gas fire pits
Ook voor Firesense 63246: Gebruiksaanwijzing (6 pagina's)

Pagina afdrukken

ASSEMBLY

PREPARATION

Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If

any parts are missing, please contact Customer Service at (866) 985-7877, 9 a.m.–9 p.m., EST., or

email [email protected].

Carefully remove the glass panels from the packaging and inspect for any damage such as chips

or cracks. Place glass panels on a soft, flat surface to prevent any damage. Before assembly, ensure

that each bracket has 2 set-screws, with silicone pads attached at the tip.

Estimated Assembly Time: 30 minutes | Do NOT over-tighten hardware!

You will assemble the wind guard upside-down. It is

recommended to assemble on the floor on a protected

surface such as a blanket to avoid accidental breakage.

Arrange the four glass Panels

Verify that all Brackets

bumper pad at the tip of both set-screws and with the set-

screws loosened adequately to allow the brackets to slide

easily onto the glass panels.

Slide a Top Bracket

Panels

as shown.

Align the Bracket with the lower (top) edges of the adjoining

Panels.

Verify that the bumper pad is in place at the tip of each

bracket set-screw. Do NOT tighten the screw directly to

the glass if the pad is missing. Check the carton for spare

pads, or contact Customer Service.

Check alignment, then carefully tighten set-screws until snug.

WARNING: over-tightening can break glass!

Continue to join Panels one at a time by the same procedure

until all four panels are joined to form a complete circle. Once

all four Top Brackets are in place, check the security of all

eight set-screws.

Hardware Used:

in a circle.

are assembled with a plastic

B/C

onto the junction of two Glass

Top Bracket x4