CalderaSpas Utopia Series Geneva Instructies voor levering - Pagina 3
Blader online of download pdf Instructies voor levering voor {categorie_naam} CalderaSpas Utopia Series Geneva. CalderaSpas Utopia Series Geneva 17 pagina's.
Pagina afdrukken
installed without gazebos or other accessories.
*NOTE: A reinforced concrete pad at least four inches thick or
structurally sound deck able to support the "dead weight" found in
the spa specification chart is required for the Cantabria
Niagara
, Elation
and Moorea
®
®
Tahitian
, Hawaiian, Martinique
®
or mesh in the pad should be attached to a bond wire.
•
Concrete sloped at 1/2 inch per 10 feet is preferred so that
rain water and water spillover will run off and not puddle
underneath the spa (water under the spa for long periods of
time may cause the wood to deteriorate).
•
If stepping stones or railroad ties are selected for the spa
foundation, they should be placed and leveled below the
entire spa to maintain even distribution of the spa weight.
•
It is important to note that soft surfaces, even when stepping
stones are used to distribute the weight of the spa as evenly
as possible, will still have a tendency to settle unevenly,
resulting in an unlevel spa.
•
Remember, placing the spa on grass or dirt may increase the
amount of debris which is inadvertently brought into the spa
water on the user's feet.
If you are purchasing a deck package or a spa enclosure with your
spa, a solid foundation becomes mandatory. Placing them on any
surface other than a single level pad could create problems with their
installation. Pictured at right are a few of the recommended surfaces.
As a homeowner, it is your responsibility to provide a suitable, level
foundation for your spa. Keep in mind that most delivery crews are not
equipped to level and prepare spa sites.
If you are interested in having a concrete slab, brick surface, or
wood deck installed, your Caldera dealer should be able to suggest a
qualified, licensed contractor.
delivery acceSS
First, locate the dimensions of your spa on the chart that is found on
the next page. The dimensions shown are the measurements of the
spa in the vertical position, laid on its side.
Next, contact your dealer to find the height and width added by the
delivery cart which the dealer will use to deliver your new spa. Use the
height of the cart plus the dimension shown as H to determine the vertical clearance required to pass the spa and
cart. Use the width of the cart, or dimension W, whichever is greater, to determine the maximum width of clearance
necessary.
NOTE: It may be necessary to allow for additional over-head clearance if the spa will be rolled up or down an incline
or moved up or down a short flight of stairs.
Use the information in the picture below to determine the requirements for access to your desired location. It may be
necessary to remove a gate, part of a fence, or other movable obstructions in order to roll the spa to its installation
site. About ten percent of the time, a crane is the only way to install the spa by lifting it to its final destination.
If the spa has to be taken off of the cart to go over a wall (either because the entry area is too narrow, the eaves are
too low, the corner is too tight, or the stairway is too steep), a crane will be required. Don't be alarmed!
™
spas, and recommended for the
™
and Kauai
spas. The reinforcing rod
®
®
FOUNDATIONS FOR SPAS ONLY
, Geneva
,
™
FOUNDATIONS FOR SPAS
(No gazebo)
PEA GRAVEL
OR CRUSHED ROCK
RAILROAD TIES
PRE-CAST
STEPPING STONES
WITH GAZEBOS
CONCRETE PADS
BRICK SURFACES
WOOD DECKING
Page 3