direct 4x4 Audi Q3 side steps Montage-instructies

Blader online of download pdf Montage-instructies voor {categorie_naam} direct 4x4 Audi Q3 side steps. direct 4x4 Audi Q3 side steps 5 pagina's. Audi q3 stainless steel and aluminium side steps

Pagina afdrukken

Audi Q3 Stainless Steel & Aluminium Side Steps Fitting

Instructions

Thank you for purchasing the Audi Q3 side steps. For fitting the item you will need a socket

or spanner set with a 10 mm bit, you will also need an angle grinder, a small hacksaw and a

knife for cutting the under body tray, a bright torch and some PVC gloves. No drilling is

required. You will need to remove the under body tray to access the fixing holes. To refit you

will need to cut slots around the brackets. A ramp will make the fitting time around 50

minutes. If you don't have a ramp fitting will take longer as you will be sharing the space

with the side steps.

Fitting Steps:

 First unpack all the boxes and remove the bolts etc from the packets.

 Next you will need to get underneath the vehicle to undo the plastic under tray. The

plastic nuts holding the tray up require a 10 mm socket. There are also some screws

that require star shaped bit to undo.

 Once you have removed or lowered the trim you can see the fixing holes and

grommets that need removing. Select the passenger front bracket and the innermost

hole can be found in front of one of the under tray fixing points.

 The other fixing point can be found near the sill and a rectangular shaped rubber

grommet needs removing to allow the fitment of a T-bolt. A T-bolt fits by putting the

long flat end in first and then pull it across to hold it in place. The threaded section

should now be showing through the hole, as can be seen above.

Page 1 of 5