Direct Healthcare Group EASY SoftBack Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Direct Healthcare Group EASY SoftBack. Direct Healthcare Group EASY SoftBack 20 pagina's.
Pagina afdrukken
9. Armrest Lock
The armrest is locked in the extended position. To lift the armrest, pull out the pin and
raise the armrest.
10. Installing Seat with the Rear Opening (Accessory)
The seat comprises two halves that are snapped in place with the aid of clamps
on the seat's underside.
11. Sanitary Pan
The sanitary pan is slid into position from behind between the seat and wire guides as
shown in fig. 11 Make sure the sanitary pan is slid into position above the wire guides.
Also make sure that the pan assumes the right position in relation to the cutout/seat and
that the pan's rear hook locks into the guide.
12. Footrest/Heel Restraint
The foot rest can be easily set to the preferred height, swung aside (lift/swing) or
removed (lift away). Set footrest height by moving the green clip to the preferred hole.
13. Castors
The Easy Hygiene Chair can feature 2 different types of wheels. The images show the
options.
A) Single wheel 125mm
The Hygiene Chair has 4 wheels (full brakes). The wheel on the right-hand front side (grey
brake pad) also features a directional lock.
B) Double wheel, 100mm
The Hygiene Chair has 4 wheels, of which the one on the righthand front side features a
directional lock and the other 3 are fitted with full brakes.
When the directional lock is activated, wheels cannot be turned. This is particularly useful
when moving heavier patients. The chair is thus significantly easier for staff to push and
control. The directional lock should be released when manoeuvring in tight spaces. The
other wheels (x 3)/green brake pad are conventional wheels that lock both directionally
and rotationally when the brakes are applied.
14. Calibrating the Actuators
The calibration of the actuators (height / lowering only) is normally done fully automatically
each time the chair reaches its end positions (min height, max tilt).
If the chair still does not go in parallel or if the tilt function does not seem to work, an
ACTIVE calibration can be done. This is done by holding down <button-slow / up> +
<button-slow / down> simultaneously.
After about 15 seconds the chair will be moved to its end positions ie. my height and
maximum slope backwards. Hold down the buttons until the end positions are reached.
Release the buttons and wait 5 seconds. The chair is now calibrated and can be used
again. Calibration should NOT be done with user in chair. Note that all 3 actuators move
during the calibration phase. Otherwise, cancel the calibration immediately and contact
Customer Service.
8
EASY SO F TBA C K
DIRECTH E ALTH C A R EG RO UP.C O M
10
11
b
a
b
12
14