Xerox 4150 - WorkCentre B/W Laser Aan de slag handleiding - Pagina 8

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Xerox 4150 - WorkCentre B/W Laser. Xerox 4150 - WorkCentre B/W Laser 38 pagina's. Mfp
Ook voor Xerox 4150 - WorkCentre B/W Laser: Brochure & specificaties (4 pagina's), Handleiding voor beoordelaars (24 pagina's), Snelle referentie (1 pagina's), Cartridges vervangen (1 pagina's), Handleiding voor installatie-instructies (40 pagina's), Module Installatiehandleiding (1 pagina's), Hardware installatiehandleiding (1 pagina's), Installatiehandleiding voor traymodule (1 pagina's), Module Installatiehandleiding (1 pagina's), Installatiehandleiding (6 pagina's), Vergelijking met concurrenten (4 pagina's), Veilige installatie en bediening (4 pagina's), Servicehandleiding (13 pagina's)

Switch On the WorkCentre

Once the WorkCentre has been assembled it must be configured. This is done using the

Product Enablement Key when the machine is switched on for the first time.

The Product Enablement Key is delivered

in a plastic tube inside the box with the

machine. The procedure to configure the

machine is as follows:

Locate the tube containing the Product

Enablement Key. Remove the plastic

card and carefully press out the key.

Install the Product Enablement Key into

the Card Reader Slot on the left side of

the machine.

Product Enablement

Key

Connect the Power Cord to the machine and a suitable power supply outlet.

Switch on the machine.

The Language Default screen will be displayed. Select your chosen language and then

select Save.

The Installation Wizard screen will be displayed. Select Next.

The Product Enablement Settings screen will be displayed. Follow the instructions on the

screen.

NOTE:

When the Green LED light stops blinking and remains on continuously (about 10

seconds), the configuration is successful.

Remove the Product Enablement Key and select Next on the display

On/Off Switch

Power Cord

Card Reader

slot

Green LED

getting started guide