Xerox 4150X - WorkCentre B/W Laser Aan de slag handleiding - Pagina 14

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Xerox 4150X - WorkCentre B/W Laser. Xerox 4150X - WorkCentre B/W Laser 38 pagina's. Finisher installation guide
Ook voor Xerox 4150X - WorkCentre B/W Laser: Brochure & specificaties (4 pagina's), Snelle referentie (1 pagina's), Cartridges vervangen (1 pagina's), Handleiding voor installatie-instructies (40 pagina's), Module Installatiehandleiding (1 pagina's), Hardware installatiehandleiding (1 pagina's), Installatiehandleiding voor traymodule (1 pagina's), Module Installatiehandleiding (1 pagina's), Installatiehandleiding (6 pagina's)

Confirm that an IP address has been allocated and that it is an appropriate IP address for

your network.

NOTE:

If the IP address starts with 169.xxx.xxx.xxx, the DHCP server has not properly

allocated an address or DHCP is not enabled on your network. Contact your network

administrator for assistance.

Network Setup Using a Static IP Address

Before you begin, obtain the following information from your network administrator:

• IP Address

• Gateway Address

• Subnet Mask

• DNS Server Address

Press the Access button on the Control Panel, enter the

Administrator's passcode [1111] and select Enter.

On the screen select Go to Tools > Connectivity and

Network Setup > Network Setup > TCP/IP Options.

Select HTTP and Enable. Select Save.

Select TCP/IP Settings.

Touch the Dynamic Addressing button. By default, DHCP

will be selected. Select Disabled to disable DHCP and

touch Save.

Select Name/Address. Enter the Host Name, by touching the Keyboard symbol. Enter the

IP Address by touching each box and entering the number using the Numeric Keypad.

Select Save.

Select Subnet and Gateway. Enter the Subnet Mask and IP Gateway. Select Save.

If you do not wish to configure DNS settings proceed to the next step. If you wish to

configure DNS settings select the DNS Configuration button. Enter the Domain Name and

the Preferred DNS Server address. Select Save.

The static IP address is now set. Select Exit Tools.

getting started guide