Xerox ColorQube 89 Series Configuratiehandleiding - Pagina 11

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Xerox ColorQube 89 Series. Xerox ColorQube 89 Series 12 pagina's. Usb card reader configuration guide for workcentre 51 series, workcentre 6400, workcentre 56 series, workcentre 75 series, workcentre 57 series, workcentre 77 series, colorqube 87 series, colorqube 89 series, colorqube 92 series, colorqube 93 series
Ook voor Xerox ColorQube 89 Series: Handmatig (32 pagina's)

Pagina afdrukken

1. Elatec Twn3 Software

RF IDeas: pcSwipeConfig.exe

ID TECH; USB Swipe & Insert Reader programming tool

http://www.idtechproducts.com/index.php?option=com_docman&task=cat_view&gid=298&Itemid=79

MagTek: MiniMag II Configuration Software

http://www.magtek.com/support/software/demo_programs/usb_swipe_insert.asp

ID TECH Magnetic Stripe Reader Configuration Upgrade

Software can be found at:

configuration-software.html

Select the IDTech_Xerox_Config.zip file to access the ID TECH MagStripe Configuration file that will be

required later in the setup process. The file is located within the

mentioned in the Prerequisites section.

Save the file to your PC for later use.

After installing (note: requires a restart) and running the Magstripe Configuration Utility:

1. Select Reader Interface button.

2. Select "USB"(Radio button below USB picture) and then select "Continue":

The reader will beep a few times and the screen will return back to the default view.

3. Select "Change Basic Reader Settings":

4. Select "Load from File":

5. Navigate to where you saved the configuration file, then select it followed by "Open":

You should get a message that loading the file was successful. Select "Ok":

6. Select "Send to MSR":

Reader will beep once or twice and you see a message that the settings were successfully

written.

7. You are now done programming the reader. Select "Close" and then 'EXIT':

http://www.rfideas.com/Software/

http://www.idtechproducts.com/download/swipe-readers/doc_download/38-

USB_Card_Reader_Install.zip

USB Card Reader Configuration Guide

file