Xerox WorkCentre Pro 65 Handleiding systeembeheer - Pagina 14
Blader online of download pdf Handleiding systeembeheer voor {categorie_naam} Xerox WorkCentre Pro 65. Xerox WorkCentre Pro 65 30 pagina's. Pdl reference guide
Ook voor Xerox WorkCentre Pro 65: Snelstarthandleiding (16 pagina's), Gebruikershandleiding (24 pagina's), Handleiding voor netwerkinstallatie (42 pagina's), Referentiehandleiding (22 pagina's)
Pagina afdrukken
How to Use this Document
NOTE
Page 1 - 2
1.
Before connecting network cabling to the WorkCentre
Pro, perform the procedure contained in the System
Administration Guide entitled How to Connect to
Ethernet.
2.
For Dynamic TCP/IP addressing refer to the section
entitled Dynamic/Static IP Addresses and WINS,
contained in the System Administration Guide.
3.
Review the Table of Contents in the System
Administration Guide. Find the network operating
system (NOS) or protocol, which pertains to your
network.
4.
Go to the page for your network and perform the
procedure(s).
5.
Once you are finished installing the system it is
recommended you print a test page.
6.
Check the print job for print quality. If print quality
problems exist, use the Problem Solving section of the
Reference Guide to correct the problem.
7.
If your print job DID NOT print, see the Troubleshooting
section for your operating system in the System
Administration Guide to correct the problem.
8.
Once your WorkCentre Pro is installed and printing, you
can repeat these steps to enable your printer to print
with additional protocols or network operating systems.
For detailed safety information about this product refer to the
WorkCentre Pro Reference Guide.
Xerox WorkCentre Pro System Administration Guide Supplement