Xerox 470 Handleiding voor snelle installatie - Pagina 27
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Xerox 470. Xerox 470 38 pagina's. Macintosh driver information
Ook voor Xerox 470: Informatie handleiding (13 pagina's)
Pagina afdrukken
Apple Macintosh (AppleTalk) Network Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
The information on this card will enable you to
print to the Document Centre with the AppleTalk
protocol from your Macintosh Computer.
Follow the steps as shown. The AppleTalk
name for your Xerox printer is set at the factory
as the network interface address of the
Document Centre. You may change the
AppleTalk Name with the PUtility program found
on the CentreWare Network Services CD. Refer
to the document supplied with your Document
Centre entitled CentreWare Network Services
Guide for details on how to install PUtility.
Record the following information:
AppleTalk Name ________________________
AppleTalk Zone ________________________
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
Go to the printer and...
1.
Connect your Document Centre to the net-
work with the appropriate cabling.
2.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
Page 1
3.
Enable the AppleTalk protocol
a)
Press the Connectivity and Network
Setup button.
b)
At the next screen, press the Network
Setup button.
c)
At the next screen, press the
AppleTalk button.
d)
At the next screen, press the Protocol
and Media button.
e)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
4.
Assign a Name and Zone to your printer.
a)
You will be returned to the previous
screen. Press the Name and Zone
button.