Xerox Synergix 8830 Software Handleiding - Pagina 5
Blader online of download pdf Software Handleiding voor {categorie_naam} Xerox Synergix 8830. Xerox Synergix 8830 30 pagina's. Windows nt 4.0 postscript print driver user guide
Ook voor Xerox Synergix 8830: Gebruikershandleiding (48 pagina's), Installatiehandleiding (20 pagina's), Release Release (23 pagina's), Aanvullende handleiding (26 pagina's)
Pagina afdrukken
Introduction
Purpose of this Guide
The purpose of this Guide is to assist you with instructions for installing a
PostScript Print Driver, adjusting the Print Driver's settings to meet your
needs, printing with the Print Driver, and removing the driver when it is no
longer needed.
Electronic copies of this Guide are available on the Internet at www.xes.com.
Basic Requirements
A Workstation running Windows NT 4.0 with Service Pack 3, or higher,
installed.
A Working Knowledge of your Workstation's Operating System.
Appropriate Cabling connecting your workstation to the network or directly
to the printer's AccXES Controller.
Appropriate protocols and ports enabled on both the printer and
workstation, with a connection established through the network or directly
between the printer and your workstation.
How to Use this Guide
1. Read "Before You Start" for valuable information on checking the
status of your communication protocols and creating a new printer port
for use with the PostScript Driver.
2. Install the driver on your workstation as stated in the Driver
Installation section of this Guide.
3. Configure the driver settings to meet your needs as stated in the
Driver Configuration section of this Guide.
XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide
4. Click OK on the Print Screen to print your job.
5. If you no longer need the driver, remove the driver as stated in the
Removing the Driver section of this Guide.
1