Xerox Nuvera 100 Hints en tips handleiding - Pagina 9

Blader online of download pdf Hints en tips handleiding voor {categorie_naam} Xerox Nuvera 100. Xerox Nuvera 100 18 pagina's. Production system
Ook voor Xerox Nuvera 100: Specificatieblad (2 pagina's), Functies Handleiding (34 pagina's), Handleiding voor planning (22 pagina's), Gebruikershandleiding (40 pagina's), Bedieningshandleiding (34 pagina's), Referentiehandleiding (2 pagina's), Handleiding voor planning (20 pagina's), Referentiehandleiding (42 pagina's), Snelle referentie (2 pagina's), Installatiehandleiding (2 pagina's), Aanvullende handleiding (48 pagina's), Handleiding voor planning (38 pagina's), Handleiding voor planning (16 pagina's), Referentiehandleiding (2 pagina's), Specificaties (2 pagina's), Hints en tips handleiding (18 pagina's), Aan de slag handleiding (26 pagina's), Aan de slag handleiding (30 pagina's)

New Capabilities in

Version 10.0

Software

The following is a list of new capabilities enabled with version 10.0 software:

•

Availability of the new Xerox Nuvera 200/288 MX Perfecting Production System

configurations. These are dual engine configurations, similar to the Xerox Nuvera®

200/288 EA Perfecting Production System, but with support for MICR printing. These

systems operate at speeds up to 200/288 impressions per minute in the duplex mode

(100/144 IPM simplex), and with 11x17 / A3 speeds of up to 120/144 duplex impressions

per minute. The primary fit for the system is a MICR-capable printing environment

running high print volumes with a high percentage of duplex pages.

•

Enablement of easier customer maintenance actions via 'wizards', in support of the 'Xerox

Productivity Plus Basic' program.

•

Added a generic Icon for DFA devices onto the Machine graph. This will assist in

differentiating faults between DFA devices and BFM/DS3500 finishers. When faults occur

on a DFA device, the Fault Icon will appear above the DFA Icon instead of above the

BFM/DS3500.

•

The new DS3500 is a stacking device that also enables other inline finishing by providing

document transport capability and full DFA support to DFA compliant finishing devices.

•

Profiles for new DFA devices introduced after a software release can now be downloaded

to connected machines. If a user purchases a new DFA device, the profile is already loaded

on the machine enabling immediate use of the new device.

•

Introduced an Alternating Set Mode for machines with dual stackers (Dual BFM). This

mode will alternate the destination of the sets of the job between the 2 stackers,

eliminating the wait times for the sets to go to the stacker. This mode is most beneficial

for small sets to dual BFM by greatly increasing productivity of these types of jobs.

Hints and Tips Guide

2-1