Alderon Industries Sump Advisor 2000559 Snelstarthandleiding

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Alderon Industries Sump Advisor 2000559. Alderon Industries Sump Advisor 2000559 4 pagina's. 2-zone alarm and sensor

Pagina afdrukken

Sump Advisor

2-Zone Alarm and Sensor

™

Rated Type 1, Indoor Alarm Panel (use with Alderon™ VertiMAC™ series)

2000514

2000558 2000559 2000560 2000561

QUICK START GUIDE

Step 2: Mounting Alarm Panel

Determine mounting location for the alarm panel, make sure the power

outlet (120VAC, 50/60 Hz) is within five feet (5') of the alarm panel. The

power outlet should be on a separate circuit breaker from any other

device and not on a switched receptacle to maintain power integrity.

CAUTION: Do not connect power to the alarm panel until the

installation of both the Sump Advisor™ alarm panel and Sump Advisor™

sensor are completed.

Alderon Industries™

Pat. No. 10,794,379

5 Feet Maximum

Safety Guidelines

Before proceeding with the installation or operation of this product,

read all instructions thoroughly, as well as complying with all federal,

state and local codes, regulations, and practices. This product must

be installed by qualified personnel familiar with all applicable local

electrical and mechanical codes. Refer to the National Electrical Code

(NFPA 70). Failure to properly install and test this product can result in

personal injury or equipment malfunction.

Step 1: 9VDC Battery Backup

Step 1A: To install or replace the battery for the backup power feature,

remove the alarm panel access cover.

Step 1B: Install the 9VDC battery matching the terminals of the wire

connector on the alarm panel to the terminals on top of the battery.

Place the battery inside the top panel compartment to secure and

ensure proper operation of the backup power feature.

Step 3: Mounting Alarm Panel

To mount the alarm panel, hold in the desired mounting location and

mark the drill hole locations. Once marked, drill pilot holes for screws (not

included) and use wall mount anchors (not included) if necessary. Place

alarm panel in the mounting location, adjust until the pilot holes are lined

up with the enclosure and fasten screws to secure the alarm panel in place.

WARNING

(continued)