eControls RT2 Handleiding voor huiseigenaar en installateur - Pagina 6

Blader online of download pdf Handleiding voor huiseigenaar en installateur voor {categorie_naam} eControls RT2. eControls RT2 12 pagina's. Wireless whf control
Ook voor eControls RT2: Gebruikers- en installatiehandleiding (8 pagina's)

Pagina afdrukken

Homes with plaster walls with steel lathe may experience wireless communication interference

when using wireless controls.

For more information on installing and using the RT2, visit the "eControls WHF Channel", RT2 Installation

Video and RT2 Homeowner Video.

CAUTIONS

Turn off power before installing whole house fan or

WHF controls.

Read and follow all instructions carefully, including

those included with the whole house fan.

Read entire manual before installing products.

Follow all local electrical codes during installation. All

wiring must conform to local and national electrical

codes.

Installation should be performed by a qualified

individual with sufficient experience and skill.

Use cautions when mounting components to surfaces

that may have concealed wiring beneath the surface.

When servicing WHF Controls or accessing products,

turn off all power to these items.

WIRELESS COMMUNICATION

The RT2 wireless control and the RM2 radio module included in this

kit have been programmed with a unique ID number and ONLY

communicate with each other.

This enables multiple WHF installations in the same home or in

neighboring homes without interference.

The ID Number on the RT2 should always match the ID Number on

the RM2 - see below.

INSTALLATION

Model RM2

WHF Radio Module

OA3MRF89XAM9A

Contains Transmitter Module FCC ID:

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any

interference received, including interference that

may cause undesired operation.

RM2

ID #

V. X.XX

01-02

1467 / 19-01

ATTENTION INSTALLER

Wire FC3J control board to WHF. Install control board

in single gang electrical box located on WHF.

Connect the FC3J control board to the RM2 radio

module using the Plug&Play cable provided.

If you are using a power cord to power the WHF,

the control board can be wired to the WHF, the

RM2 radio module connected to the control board

and options set before sending out for installation.

Install optional Outdoor Temperature Sensor and

wire to the RM2.

Install batteries in the RT2 and set options.

5) Power WHF only after setting options. Test installation.

Same

ID Number

Model RT2

Pat. Pend.

Wireless WHF Control

Made in USA

eControls

Laguna Hills, CA / eControlsUSA.com

Contains Transmitter Module FCC ID:

OA3MRF89XAM9A

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) this device may not cause

harmful interference, and (2) this device must

accept any interference received, including

interference that may cause undesired

operation.

RT2

ID #

Ver X.XX

01-02

1234 / 19-01