Yamaha AvantGard N3 Onderhoudshandboek - Pagina 33

Blader online of download pdf Onderhoudshandboek voor {categorie_naam} Yamaha AvantGard N3. Yamaha AvantGard N3 45 pagina's. Hybrid piano

N3 TOP BOARD (F) ASSEMBLY-REPLACEMENT PROCEDURE

1. Required items for task

Service personnel shall possess the physical strength needed to replace the top board in a grand piano.

To ensure safety, 2 or more persons shall perform this task.

2. Required parts

The task requires the usual tools, the top board (F) assembly dedicated service part (ZE082300), and the top board

(F) adjuster part set (ZE082400). The following parts are included in the top board (F) adjuster part set.

• Fall board rubber buttons A thru C (H=3.5/4.5/5.5mm) 2 pieces each

3. Replacement procedure

3-1 Fold the top board (F), and remove the screws on the top board (F) side of the long hinge that clamp the top board

(B) and top board (F).

• Fold the top board (F) as shown below, and remove the 21 truss screws in the red-framed section (A) in the

photo.

3-2 Dismantle the top board (F) and remove from the main unit. (Fig. 1)

3-3 Mount the top board (F) assembly dedicated service part (ZE082300) over the top board (B) so that the attached

top board (F) ﬁ ts over it.

3-4 Adjust left and right so that there is no dimensional difference between the top board (F) and top board (B) edges

as aligned along the dotted yellow line (B). (Fig. 1)

3-5 Align the long hinge on the top board (B), with the top board (F) assembly dedicated service part. Adjust the

height difference between the top board (B) assembly and top board (F) assembly dedicated service part by

inserting felt or a similar item in between to match the height of the long hinge.

3-6 Align with the hole positions in the hinge and drill pilot holes at the 21 positions in the top board front assembly

service dedicated part.

3-7 Tighten up 21 truss-head screws on the pilot holes.

Fig. 1 Top board (F) and top board (B) relative positions