Yamaha AW4416 Handmatig supplement - Pagina 18
Blader online of download pdf Handmatig supplement voor {categorie_naam} Yamaha AW4416. Yamaha AW4416 48 pagina's. Installing an internal hard disk
Ook voor Yamaha AW4416: Supplement handleiding (1 pagina's), Les (34 pagina's), Supplement handleiding (20 pagina's), Handmatig (3 pagina's)
Pagina afdrukken
AW4416 Version 2.0 Manual Supplement
7
Operate the sustain pedal connected to
your synthesizer.
A control change #64 (Hold-on) message with a
value of 127 (hexadecimal 7F) will be input in
the [ON] key message area.
In this message, the first value in the boxes
extending toward the right (i.e., the first byte) is
the MIDI channel, the second is the control num-
ber, and the third byte is the actual value of the
message.
8
Turn off the LEARN button, and take your
foot off of the sustain pedal.
Tip!
If you take your foot off the sustain pedal before turn-
ing off the LEARN button, a control change #64 with
a value of 0 (hexadecimal 00) will be input in the
MIDI message display area. However even in this
case, the following steps will not be affected.
9
Move the cursor to the location of the third
byte, and use the [DATA/JOG] dial to
change the value to "SW."
The byte whose value was set to "SW" will be
transmitted as 127 (hexadecimal 7F) when the
[ON] key is turned on (lit), and as 0 (hexadeci-
mal 00) when the [ON] key is turned off (dark).
Tip!
• It is also possible to input an entire MIDI message
manually in this way. In this case, be sure to specify
"END" at the end of the MIDI message.
• If you want a specific MIDI message to be transmit-
ted each time you press [ON] (for example if you
have assigned a program change), it is not necessary
to input the "SW" value.
If you input a MIDI message manually, it is possible to
input an inappropriate or invalid message. If such a
MIDI message is transmitted to a connected external
device, the device may malfunction. Please use cau-
tion.
18
10
Make sure that the Remote function of the
currently-displayed page is enabled
(ENABLE), and operate the [ON] key to
which the MIDI message was assigned.
When you press the [ON] key, the key LED will
light and a Hold-on message will be transmitted.
When you release the [ON] key, the key LED will
go dark and a Hold-off message will be transmit-
ted.
Tip!
It is also possible to change the operation of the [ON]
key so that the on/off status is switched each time you
press the key. For details refer to the explanation of
the LATCH/UNLATCH button on page 34.
11
If you want to assign a name to the [ON]
to which the MIDI message was assigned,
move the cursor to the NAME EDIT button
for the [ON] key, and press the [ENTER]
key.
The NAME EDIT popup window will appear.
12
Use the character palette to input a name,
and move the cursor to the OK button and
press the [ENTER] key.
The name you input will be displayed below the
channel button located in the lower part of the
display.
Tip!
The edited content of the REMOTE screen is saved as
part of the song.
[Reference pages]
Details on the Remote A 1-8/Remote A 9-16/Remote
B 1-8/Remote B 9-16 pages
Version 2.0 Manual Supplement
P.33