Yamaha YCH-585 Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Yamaha YCH-585. Yamaha YCH-585 4 pagina's. Chimes

Pagina afdrukken

Warning

Before you use the chime, carefully read the instructions listed below and the owner's manual.

Never place the instrument on an sloping, unstable, etc., platform. The instrument may fall or overturn and result in injury.

Never lean on or climb onto the instrument. The instrument may fall and result in injury.

Do not play or roughhouse around the instrument. Bumping into the instrument may result in injury.

It may also cause the instrument to fall over. Keep children away from the instrument.

If an earthquake occurs, strong shocks caused by the earthquake may overturn the instrument or cause it to move about.

Stay away from the instrument during earthquakes.

1. When moving with the casters, move on smooth surfaces only. Do not move on sloping,

rough or gravel surfaces. The chime may overturn, roll away recklessly causing injury.

2. Move the instrument only after making sure that the caster locks are off. If the instru-

ment is moved with the casters locked, it may overturn.

3. Two persons are required to move the instrument. As shown in the illustration, both

persons should hold the stand by its side columns and move the instrument slowly in

the direction you want to go. Do not run. It may be impossible to stop the instrument,

bump into the wall and cause injury.

Weight, YCH585 about 84 kg. If the instrument must be lifted, use as many people as

possible and lift it being careful not to cause any injury. Make sure that the hanger (the part

from which the sound columns are suspended) is always upright. Never allow the base to

be higher that the hanger. The sound columns will fall.

With the instrument fully assembled, do not transport up or down a staircase. Parts may fall off, balance may be lost causing.

Caution

If the instrument is often moved, bolts, parts, etc., may be-

come loose. After moving the instrument, check and make

sure all bolts, parts, etc., are firmly fastened. Firmly tighten

all loose items.

1 Never use a metal type hammer or

mallets to strike the sound column

with. The sound column will break.

2 Always use the instrument on a flat,

level surface. The instrument will not

function properly on a sloped surface.

3 When assembling the stand, make

sure each part is firmly attached, and

there is no twisting or disfigurement

in the frame. Also, make sure that

all wing nuts are firmly tightened.

4 Use your toes to operate the damper

pedal. Do not stand on or put your

weight on the pedal. Doing so may

cause the pedal to break.

5 Do not touch the damper adjuster

(shown in the illustration right). The

adjuster has been adjusted at the

factory. Moving the adjuster may re-

sult in the damper not functioning

properly.

PRECAUTIONS

Disregard of the warnings with this mark or misuse may

result in death or personal injury.

Cautions when setting the instrument.

Cautions for treatment of the instrument.

Cautions when moving the instrument.

Injury or handicaps to persons caused by the disregard of warnings with this mark

or, misuse of the instrument, may result in the loss of personal property.

Before you use

Damper Adjuster

6 When playing the chime, make sure

the caster brakes are firmly set and

the chime stand does not move

about.

7 Do not keep the chime in a place

where high temperatures and high

humidity are present. Doing so will

result in the shortening of the instru-

ments life.

8 For regular cleaning, wipe with a soft,

dry cloth. Never wipe with thinner,

or polishing preparations.

Do not use the hammer for anything other than playing the

instrument. It may be the cause of injury or accidents. Do

not let children strike other, etc., with the hammer. Do not

allow such dangerous behavior to take place.

■ Be careful when transporting

1 When transporting or moving the instru-

ment, do not subject it to strong shocks.

2 The sound column's pitch and/or

tone may change if the columns are

scratched or bent. Be careful.

3 When the instrument is to be trans-

ported over long distances, especially

by vehicle, do so with the sound col-

umns removed from the stand. The

shape of the stand may change and

the column's wire/strings may be cut

if the columns are not removed.

4 When attaching or removing the

sound columns, do so in a place

where there is sufficient room so that

the columns do not come into con-

tact with other objects.

5 After the sound columns are removed,

wrap them in a soft cloth, etc., to pre-

vent scratching, and then transport.

Hold the stand by its side

columns and move slowly in

the direction you want to go.