Yamaha YM-5104A Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Yamaha YM-5104A. Yamaha YM-5104A 16 pagina's. Concert marimbas

ASSEMBLY

YM-4600A Only

5-2. As YM-4600A does not have a resonance regulator, insert resonators into resonator holders as

shown below.

* The resonators are factory adjusted so that the optimum resonance level

is obtained at 23°C. If desirable resonance is not available due to the

temperature lower or higher than 23°C, adjust setting of the resonators.

Move the resonators to fit into longer grooves when the temperature is

higher and into shorter grooves when the temperature is lower.

Temperature

Higher

Around 23°C Center groove ("B")

Lower

Adjust the height of the tone bars.

While supporting the frame end of the leg by hand, loosen the fixing bolt of the slide guide on both

large end and small end sides.

Adjust the height to the desired level and tighten the fixing bolts securely.

When adjusting the height, use the lines on the slide guide for reference and make the tone bars in

parallel with the floor surface.

Upon completion of assembly, check to make sure that each bolt is tightened securely.

Grooves to use

Short groove

("A" in the figure right)

Long groove ("C")

A : For a higher temperature

B : For a temperature around 23°C

C : For a lower temperature

Fixing bolt

Resonator

holder