CALI alumLEDs ALS500T-SWM-TB Handleiding voor installatie-instructies - Pagina 8

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} CALI alumLEDs ALS500T-SWM-TB. CALI alumLEDs ALS500T-SWM-TB 20 pagina's.

Pagina afdrukken
9
Adjust Cable Gripper by unscrewing locking mechanism. Press down and hold
the threads where cable feeds through. Pull cable from the exit. Let go of threads
to lock in place, then replace locking mechanism.
Unscrew & lift
10
Slide luminaires onto Aircraft Cable Assemblies. Adjust positioning of lower hex
nut if needed to allow assemblies to slide in easily. Always install corners first.
11
If applicable, install end cap to end of run.
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Press down & hold
Pull cable
Slide luminaires onto
Aircraft Cable Assemblies
ALS500T-SWM-TB
Mounting (Aircraft Cable Assembly) 2 of 3
12
After all luminaires have been mounted, secure Aircraft Cable Assemblies to
luminaire by tightening lower hex nuts. All aircraft cables must rest in a vertical
position. Do not allow aircraft cables to rest at a slant or angle. Adjust as needed.
Note: The position of the Aircraft Cable Assemblies may deviate from the
spacing diagrams due to variations within the installation area. Ensure all
luminaires are appropriately balanced.
Tighten hex nuts
to secure in place
13
Secure connections between continuous runs using Connector Blocks after all
luminaires have been mounted.
Note: Refer to steps on page 16 for details.
14
Install Ceiling Trim after all luminaires have been mounted and connected.
Note: Follow the steps on page 17 to install Ceiling Trim.
15
After all luminaires are mounted, adjust height and levelness of each luminaire
by adjusting cable gripper. Allow the weight of the luminaire to be suspended by
the aircraft cable while simultaneously resting on the flange of the T-Bar.
Note: One person holds the luminaire and another person adjusts cable gripper.
INSTALLATION INSTRUCTIONS
Adjust length as needed
Trim excess cable
Ceiling Trim resting on T-Bar
1 / 29 / 2021 / Rev 2
Page 8 of 20