Yamaha KX88 Geautoriseerde producthandleiding - Pagina 11
Blader online of download pdf Geautoriseerde producthandleiding voor {categorie_naam} Yamaha KX88. Yamaha KX88 38 pagina's. Midi master keyboard
Ook voor Yamaha KX88: Gebruikershandleiding (38 pagina's), Gebruikershandleiding (38 pagina's), Servicehandleiding (17 pagina's)
Pagina afdrukken
CHAPTER 2: FUNCTION OF THE KX88
SUMMARY OF THE KX88
OPERATION MODES
n
The KX88 has three modes of operation: PLAY mode, CA
mode, and PA mode.
You will normally play the KX88 in PLAY mode. When
you operate the various controllers while in this mode, the
MIDI data that has been assigned to the controllers will be
sent.
In CA mode, you may assign functions (controller codes
00-FF) to the various controllers.
In PA mode, you may define controller codes 40-FF to
be any desired MIDI information. Controller codes 00-3F
have been preset at the factory and cannot be changed.
Pressing MODE will take you back and forth between
PLAY and CA modes. To enter PA mode, press MODE for
about 1 second while in CA mode. Pressing MODE again
will take you back to PLAY mode.
MIDI CHANNEL
The KX88 sends MIDI channel messages on two channels
simultaneously. We will call these MIDI BANK A and B.
The channel number for each bank may be set independ-
ently.
FUNCTIONS OF THE KX88
PLAY MODE
When Wheel 1-2, Breath Controller, After touch, CS1-4,
Foot Controller 1-2, MS1-5, and Foot Switch 1-2 are
operated, MIDI status and data will be sent, according to
the controller code that has been assigned to that
controller.
TS1-2
These are each assigned two functions, which are alter-
nated each time they are pressed. The indicator LED for
each switch shows which function is next.
Program select switches A 1-16, B 1-16
Banks A and B send MIDI program select messages on
independent channels, and you can select voice programs
independently for each bank, using the bank switches
and program select switches. In 2 bank mode you can
select voice programs 1-32, and in 8 bank mode, voice
programs 1-128. (See page 20)
Keyboard modes. The KX88 keyboard sends MIDI key
on/off information in three modes.
SINGLE; Key on/off information will be sent on either
bank A or B. Select bank A or B by pressing a bank
switch or program select switch of that bank.
DUAL; Key on/off information from the entire key-
board will be sent on both banks A and B.
SPLIT; Keys lower than (or equal to) the selected split
point will send key on/off information on MIDI bank A,
and keys above the split point will send key on/off infor-
mation on MIDI bank B.
CA MODE
n
In CA mode, the program select switches perform the
functions printed above them. Use the bank A program
select switches 1-10 to select controllers Wheel 1-Foot
controller 2. The bank switch LEDs indicate which bank
(A, B or both) this controller is active for. You may
enable/disable each bank by pressing its bank switch.
The upper readout will show which controller you have
selected. (see below)
The lower readout will show the current controller code
assigned to that controller. When you enter a new control-
ler code (using bank B program select switches 1-16), it will
be displayed in the lower readout and the controller assign-
ment will change to the controller code you have just
entered.
- 9 -