Yamaha MOTIF ES7 Software Handleiding - Pagina 30

Blader online of download pdf Software Handleiding voor {categorie_naam} Yamaha MOTIF ES7. Yamaha MOTIF ES7 36 pagina's. Voice editor
Ook voor Yamaha MOTIF ES7: Software-installatiehandleiding (35 pagina's), Software Handleiding (33 pagina's)

Pagina afdrukken
Yamaha MOTIF ES7 Software Handleiding
"Setup Dialog"
Settings made here control how data is sent between the Multi Part Editor and the MOTIF ES6/7/8
or the 01X.
(page
17)
1
2
3
4
5
6
7
1 MIDI In Remote Port ....... Click this and Select a remote MIDI input port.
n
When running Multi Part Editor as an SQ01 plug-in, the remote input port name set in the SQ01 will
be displayed here.
2 MIDI Out Remote Port .... Click this and Select a remote MIDI output port.
n
When running Multi Part Editor as an SQ01 plug-in, the remote output port name set in the SQ01 will
be displayed here.
3 MIDI In Port..................... Click this and Select a MIDI input port.
4 MIDI Out Port .................. Click this and Select a MIDI output port.
5 Device No........................ Required for transmitting/receiving system exclusive data (bulk data)
6 Dump Interval ................. Sets the interval between packets of data when transmitting/receiving
7 Dial Mouse Control ......... Changes the operation of the parameter knobs.
n
The setting made here affects all knobs.
8 OK................................... Click this to use the new settings and close the dialog.
9 Cancel............................. Click this to close the dialog without changing the settings.
8
Data from the MOTIF ES6/7/8 will be received on this port.
Multi Part Editor will control the MOTIF ES6/7/8 by sending data on
this port.
to and from MOTIF ES6/7/8. Set this to match the device number of
the MOTIF ES6/7/8.
bulk data to the MOTIF ES6/7/8.
When "Rotate" is selected, the parameter values (of the panel
"knobs") are changed by clicking and dragging the mouse in a circular
direction - in the same way as turning an actual knob.
When "Up/Down or Left/Right" is selected, the parameter values (of
the panel "knobs") are changed by clicking and dragging the mouse
vertically or horizontally - in the same way as operating a slider.
30
9