Yamaha HTR-5920 Gebruikershandleiding - Pagina 43

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Yamaha HTR-5920. Yamaha HTR-5920 45 pagina's. Digital home theater system av receiver
Ook voor Yamaha HTR-5920: Servicehandleiding (38 pagina's)

Pagina afdrukken

Audio information

ITU-R

ITU-R is the radio communication sector of the ITU

(International Telecommunication Union). ITU-R

recommends a standard speaker placement which is used

in many critical listening rooms, especially for mastering

purposes.

LFE 0.1 channel

This channel is for the reproduction of low bass signals.

The frequency range for this channel is 20 Hz to 120 Hz.

This channel is counted as 0.1 because it only enforces a

low frequency range compared to the full-range

reproduced by the other 5 channels in Dolby Digital or

DTS 5.1-channel systems.

PCM (Linear PCM)

Linear PCM is a signal format under which an analog

audio signal is digitized, recorded and transmitted without

using any compression. This is used as a method of

recording CDs and DVD audio. The PCM system uses a

technique for sampling the size of the analog signal per

very small unit of time. Standing for "pulse code

modulation", the analog signal is encoded as pulses and

then modulated for recording.

Sampling frequency and number of

quantized bits

When digitizing an analog audio signal, the number of

times the signal is sampled per second is called the

sampling frequency, while the degree of fineness when

converting the sound level into a numeric value is called

the number of quantized bits.

The range of rates that can be played back is determined

based on the sampling rate, while the dynamic range

representing the sound level difference is determined by

the number of quantized bits. In principle, the higher the

sampling frequency, the wider the range of frequencies

that can be played back, and the higher the number of

quantized bits, the more finely the sound level can be

reproduced.

Video signal information

Component video signal

With the component video signal system, the video signal

is separated into the Y signal for the luminance and the P

and P

signals for the chrominance. Color can be

reproduced more faithfully with this system because each

of these signals is independent. The component signal is

also called the "color difference signal" because the

luminance signal is subtracted from the color signal.

A monitor with component input jacks is required in order

to use the component signal for output.

Composite video signal

With the composite video signal system, the video signal

is composed of three basic elements of a video picture;

color, brightness and synchronization data. A composite

video jack on a video component transmits these three

elements combined.

GLOSSARY